根据分析结果判断，“载荷组”的允许载荷需要进行调整，以符合技术规范的特定要求。
Depending on results of the analyses the "load Group" allowable loadings may be modified to suit the specific requirements of the technical specification.
设计工程师负责对分析结果进行评审。按照标准载荷组载荷要求，对载荷进行调整的相关事宜，由管架集团工程总监作出最终决定。
Review of the results will be performed by a Design engineer and decisions regarding modification to standard load group loadings will be determined by the PSG Engineering Director.
对多钉连接件钉传载荷的计算问题提出了一个解析分析方法，推导了求解钉载的线性代数方程组并给出了若干算例。
A new analytical method of pin load computation for joints with multi-rivets or multi-bolts is presented by means of mathematical theory of elasticity and classical principle of structural mechanics.
通过17组试桩的载荷试验及计算，对挤压支盘桩的承载能力进行了计算分析与研究。
Based on the data obtained from the 17 groups of statistic loading tests and the corresponding calculation analysis, the load bearing capacity of Impaction Rootage-shaped Pile is investigated.
在单循环载荷时，三组固定方式在内固定失效的最大载荷及线性固定钢度无显著性差异。
No significant differences between the three fixation groups were observed in the parameters maximum load to failure and linear fixation stiffness with monocyclic loading.
结果得出了对照组和实验组动物肘关节尺神经拉伸最大载荷，最大应力，最大应变，弹性模量等数据。
Results We got out the data of stretch ultimate load, maximum stress, maximum strain, elastic modulus on elbow joint ulnar nerve between control group and experimental group.
钢环组是金属带的关键组件之一，它的载荷分布关系到金属带的承载能力和使用寿命。
Steel ring is a key part of metal V-belt; the load distribution on its has a great influence on its driving capacity and its service life.
本文对该方程组采用载荷增量法进行迭代求解。
The load increment method is used for the solution of the nonlinear algebraic equations.
由于当地首次采用加筋垫层，为了检验其效果，进行了多达21组载荷试验，并进行了沉降观测。
The geogrid reinforcement cushion is used underneath the footing. However, due to lack of experience of local soil, 21 field loading tests were carried out to verify the effect of geogrid cushion.
对于在移动集中荷载组作用下的连续梁，应用这些公式，可求得最不利载荷位置和最大绝对弯矩。
According to these equations, both the most unfavorable loading location and the maximum absolute bending moment of continuous beam loaded under a group of movable loads can be found.
结果：经统计分析，结果显示纤维桩修复组样本断裂载荷显著高于对照组，其断裂模式较对照组更为有利。
Results: Statistical analysis revealed that specimens with fiber posts demonstrated significantly higher failure loads and favorable fracture pattern compared to the controls.
首先建立了考虑温度及离心载荷的双重边界积分方程组，并对边界积分方程组的选取及适用范围进行了讨论。
First, dual boundary integral equations with temperature and centrifugal loads are set up in the paper. Then, the strategy to use those equations is discussed.
在相同轴向压缩载荷作用下，AFC组椎弓根钉受力移位较内固定组明显减小。
Under the same axial compression load, the dislocation of the pedicle screw in AFC group was apparently less than that in fixation group.
该类轴承只能承受单方向的轴向载荷，如果单个轴承的载荷不能满足需要，或者要求承受两个方向的轴向载荷时则选用轴承组。
Thurst angular contact ball bearings only bear unilateralism axial load. If single bearing loading couldn't meet request, or bear double direction axial load, it should choose bearing combine.
结果：（1）与假手术组比，骨质疏松对照组的股骨颈最大载荷、第2腰椎最大凹入载荷和第3腰椎最大压缩载荷3项力学性能指标分别降低了50%、40%和27%（P<0·05）。
Results (1)Three mechanical indices of FN, L2 and L3 in rats of OVX decreased by 50% (P<0.05), 40%(P<0.05) and 27%(P<0.05), respectively as compared with that of SHAM.
结论：静态及循环载荷条件下，第二组的抗弯刚度明显小于第一组。
Conclusions: Under static and cyclic bending conditions, stiffness in group 2 was significantly lower than that in group 1.
方法：20只家兔随机分为两组：模型组和正常组，模型组通过外载荷力的作用，制作CS A动物模型。
Methods: 20 rabbits were randomly divided into two groups: model and normal group. CSA animal models were made by appling outside load.
结果：与S组大鼠比较：G1组弹性载荷、最大载荷和刚性系数显著恢复（P <0 .0 5 ） ；
Results: Compared to S rats, elastic ultimate load (EUL), the ultimate load(UL) and bending rigidity coefficient (BRC) of G1 rats ( P <0.05) improved significantly;
对塔机双吊点水平动臂在主载荷下的线性和非线形变形，拟建立其通用的变形方程组，以便对其变形和内力进行普遍的计算。
This paper will establish a general deformation equation group for two-hanging point horizontal boom of tower crane, therefrom its deformation and internal force can be universally calculated.
结果：缺损直径为1.5毫米、2.0毫米组鸡胫骨达到结构破坏时的最大载荷与完整皮质对照组无显著差异。
Results: When bone destruction was happen, there was no difference of the maximum load on statistics between 1.5mm group, 2.0mm group and control group;
结果：缺损直径为1.5毫米、2.0毫米组鸡胫骨达到结构破坏时的最大载荷与完整皮质对照组无显著差异。
Results: When bone destruction was happen, there was no difference of the maximum load on statistics between 1.5mm group, 2.0mm group and control group;
应用推荐