动态分析的对象是交流通路，图解法动态分析的关键是作交流负载线。
The most crucial point to the dynamic analysis is the drawing of alternating current load line .
所设计的射频2W线性功率放大器是基于负载线匹配原理，采用功率回退法技术。
The 2W linear RF Power Amplifier in this paper is designed in Feedback method, based on Loadline Theory.
文章提出了一种新的分析放大器电流通路的方法，并由此直接得到了交流负载线方程。
We has brought forward a new method of analysing amplifier current path, and has got the equation of Alternating load line directly.
一旦缓存线负载，进一步的读入数据会更快并且多余的只读存储存取会被避免。
Once the cache line is loaded, further reads are much faster and extra RAM accesses are avoided.
不带软铜编织线的磁保持继电器，负载引出脚不能锡焊，不能随意扳动，且不能同时刚性固定两个引出脚。
Not with braided line relay, the load pin can not solder, not arbitrarily wrenched, two pins and rigid fixation.
多点连接链的优点是很多低负载量的基站可以(与)一个单一的2M脉冲编码调制线挂钩。
The advantage of multidrop chain is that many low-capacity stations can be tied to a single 2m PCM line.
根据出货计划平衡生产线负载合理安排人力。
Balance line loading and arrange opertors according to delivery requirments.
本文以三线制npn式开关量输出型传感器为例，介绍了传感器的负载驱动单元的结构特点及驱动方式。
Taking a sensor of switch - output type NPN for example, its structural characteristic of the load driving unit and the driving pattern is introduced in this paper.
高牙尖斜度与非中心线负载可引起高应力集中。
Higher inclination of cusp and non central loading lead to higher stress.
本文提出了一个用自动测量线的六端口技术，使校准网络参数的标准负载仅用一个。
This paper advance a six-pore reflectometer of automatic slot line, only one standard load is on calibrating network parameter.
使用：接好电源、负载及热电阻线后，按下温控器电源开关，温控器即可自动投入定温控制运行。
Operation: Once get power supply, loads and thermal resistors connected, press the power switch of temperature controller, and then it will start temperature control program automatically.
步进电动机象同步电动机一样，在负载转矩的作用下，转子磁极中心线将滞后于气隙磁场的中心线一个角度，称为失调角。
Like synchronous motor, rotor magnetic pole center line could lagged behind an Angle of that of air-gap magnetic field under the function of load torque (called angular displacement).
最低负载电流是必要的运作无误的两线设备。
The minimum load current is necessary for flawless operation with two-wire devices.
电力线载波技术分为两类，一种是用于负载控制、远程抄表和家电自动化的低速电力线载波通信。
There are two kinds of Power Line Carrier technology. One is used for Load Control, Remote Meter Reading and Home Automation, which is a short rate application.
该模型将微带线的有效阻抗作为匹配负载电阻，然后按适当的比例分布到端接面的网格中。
The model uses the effective impedance of the microstrip line as the value of matched resistive load and assign it into the RL mesh region in a proper proportion.
理论计算表明，改造真空磁绝缘传输线，减小其自身电感，会提高能量传输效率，能够增大负载电流。
In theory, the decrease of the vacuum magnetic insulation transmission line inductance can heighten the energy transmission efficiency, can increase the load current.
采用矩量法技术来分析接任意负载的微带传输线和微带弯折。
The MoM technique is used to deal with an arbitrary load microstrip transmission line and bend.
现在，你需要一个可变电源连接电池线，或某种可变负载。
Now you need either a variable power supply connected to the battery lines, or some kind of variable load.
您还可以使用可变电源的面板倾斜远离太阳，而固定的负载连接电池线。
You may also use your panel as variable power supply, by tilting it away from the sun while a fixed load is connected to the battery lines.
为了使传输线能够将信号源的信号高效不失真地传送到负载，需要考虑阻抗匹配问题。
The problem of impedance matching must be considered in order to transmit the signal of generator to the load efficiently and distortionless by transmission lines.
由于这个电流不通过负载流量，同时可连接三线传感器的最大数量只取决于电力供应。
Since this current does not flow through the load, the maximum number of parallel connectable three wire sensors depends only on the power supply.
根据出货计划平衡生产线负载合理安排人力。
Research and Implementation of Load Balancing in Mass Secure Card System;
这些影响和负载都集中在一个点或线的接触追随者和摄像机，如前所述。
These impacts and loads are concentrated at a single point or line of contact between follower and cams, as mentioned before.
采用吸附仪测定了所制负载金属活性碳纤维的吸附等温线，然后用不同理论方法对孔径分布进行表征分析。
The pore distribution of metal coating activated carbon fibers were analyzed by HK, BJH and Dubinin theories from the nitrogen adsorption isotherms measured by auto adsorption meter.
在装置“S- 300”上，通过测量真空磁绝缘传输线中电极间电子流轫致辐射和负载上的电流、电压等参数，研究了磁绝缘传输线中的电流损失特性。
The current loss in magnetically insulated transmission line (MITL) on pulsed power installation "S-300" is studied by measuring bremsstrahlung between the electrodes, current and voltage in the load.
在均匀多导体传输线的时域有限差分法(FDTD)基础上，对非均匀多导体传输线及端接非线性负载的情况进行了分析。
Based on the uniform multi-conductor transmission lines (MTL), the FDTD method is adopted to research the transient response of the nonuniform transmission lines with nonlinear loads.
提出了一种新的低功耗非冗余排序总线编码方法，通过对改进的偏移地址线的动态重排以降低具有高负载的地址总线的功耗。
The irredundant sorting bus encoding method reduces the power dissipation of highly capacitive memory address bus based on the dynamic reordering of the modified offset address bus lines.
采用分布式电容负载型结构设计出毫米波薄膜介质移相器，其中的高阻传输线为有限宽度地共面波导。
The distributed BST capacitor-loaded phase shifter was designed, of which the high impedance transmission line is finite ground coplanar wave-guide (FGCPW).
针对具有非线性负载的非均匀耦合传输线瞬态响应灵敏度分析困难的问题，提出了一种采用快速傅里叶变换的灵敏度分析方法——傅里叶变换法。
Since the sensitivity of nonuniform coupled transmission lines with nonlinear loads is hard to analyze, a new method based on fast Fourier transform is proposed.
能够打印多达6线意味着你可以创建信息负载标签。
The ability to print up to 6 lines means you can create labels with loads of information.
应用推荐