应用分子钟也是一种手段，但误差比较大。
The application of molecular clocks is another approach, but it carries even greater errors.
闭路制导方法是一种实用的方法误差比较小的制导方法。
Close-loop guidance is a kind of method with practicality and less error.
由于小料的称量误差比较大，严重制约了优质浮法玻璃的生产。
The weighing error of ingredient is larger, which seriously influences on production of high quality float glass.
然而，当目标位置的互距离测量误差比较大时，CMKF的性能将急剧下降。
However, it has been found that the performance of CMKF degrades considerably when cross-range measurement errors of the target position are large.
针对单点定位误差比较大的特点，提出了用两点相对定位的测量方法来减小定位误差。
Aimed at the characteristic of bigger single point location error, a new measuring method using two points relative location measurement to reduce location measurement error was put forward.
试验分析结果表明：感热通量对观测要素的观测误差比较敏感，因而其计算结果的误差较大；
The results show: sensible heat flux are sensitive to observation error, so the error of model calculation is great;
虽然OFDM是一种优良的宽带传输技术，但是它也存在致命的弱点，那就是它对误差比较敏感。
Though OFDM is an excellent broad band transmitting technique, it's weakness is fatal, that it is sensitive to error signals.
采用Cox稳健标准误差模型来比较项目村庄和对照村庄五岁以下儿童的死亡风险。
Cox models with robust standard errors were used to compare the hazard of death among children under 5 years of age in project and control villages.
由于这个原因，我们已在这次提交材料的附录中包括了我们的跟踪误差以及其它定量数据，这样，你就能在一个比较的基础上进行评估。
For this reason, we have included our track record and the other quantitative data in this submission as an additional annex so that you can assess it on a comparable basis.
通过增加评估的可变性，将风险分散到各个目标往往比较主观，也能很好地实现——事实上，是通过扩大“误差范围”。
Factoring risk into goals tends to be subjective and is best accomplished by increasing the variability of the estimates — in effect, by widening the "margin for error".
然后进行误差分析和比较。
比较了计算结果与实测值，并分析了误差产生的原因。
The calculation results and the measured results are compared and the reasons causing the error are analyzed.
然而，在苛刻光照条件下，这种近似的误差往往比较大，以至于很难恢复出反射率信息。
However, the approximation error can be large under harsh lighting conditions, thus making it difficult to recover albedo information.
并且采用增益误差校正技术和比较器数字校正技术这两种校正技术。
And applied gain error correct technology and comparator digital correct technology to the architecture.
估计一下在秤量，使用滴定管和确定终定位置的不确定度。用这些值计算误差传播而且跟所观测值比较一下。
Estimate what you think the uncertainty is in weighing, using the buret, and in endpoint location. Do error propagation from these values and compare with the observed precision.
该模式采用直接预报的方法，避免了误差累积效应；对训练集实时更新，以保证模式的不断更新；模式的输入比较简单，便于应用。
This model adopted direct prediction method, so error accumulation effect was avoided. The training data set was real-time updated so that the model was always the newest.
用幂函数模型描述的回归曲线以及根据试验参数得到模拟曲线与试验值比较误差均较小。
The errors of the data obtained using the power function model are very small from the test data.
比较详细地分析了快速汉克尔变换误差原因，给出修正方案，有效地提高了算法精度。
The article has analyzed error cause of fast hankel transform in detail, and the correction schemes are gived, and has effectively raised the algorithm accuracy.
本文用几何光学描述了离轴探测调焦误差信号与系统参数的关系，并与实验结果进行了比较。
Characteristics of the defocusing error signals are expressed in the terms of an off-axial detection system by geometric optics. The results are compared with experiment.
将被测仪表显示数与计算机内的测量值比较，其误差曲线即可确定该被测仪表的精度。
This value is compared with measuring value in computer so that error curve is gained for determining the precision of the instrument.
作为常规的处理信号估计的方法，递归最小二乘法具有能够在估计的时候产生相对比较小的误差。
Act as routine dispose signal estimation route to, recursion least square method possess in a position to at approximate time bring relative comparison small error.
对四种模型情况进行了全面比较和误差分析。
Comparison and error analysis of four different mathematical models are made.
通过算例证明，采用简化法计算结果与分段法比较，其误差不到1%，完全可以满足工程要求。
Instances prove that error didn't exceed 1%. Compared with stage-method, simplified calculation can satisfy the needs of engineering completely.
该方法与人工分类、神经网络、决策树等方法比较，其测试误差低，测试速度高。
Compared with artificial classification, nerve network, and decision tree, its test error is low and the speed is high.
通过误差分析与比较，把增长曲线模型引入到多级荷载下的路堤沉降预测中。
For the multistage loadings of embankment, the logistic curve model to embankment settlement predication is put forward by error analyses and comparisons.
针对实验室现有的设备，分别对单点定位误差和区域定位误差进行试验、分析，对不同GPS使用精度进行比较。
Based on the facility the lab owned, we analyze single error and region error and compare different GPS precision.
外部熟练鉴定还为实验室内部测量误差提供了时时比较程序。
External proficiency testing also provides an ongoing comparison of inter-laboratory measurement error.
并且对于两种方法的计算结果进行了比较，误差不大，都在可以接受的范围内。
And comparing the calculation result of two kinds of methods, error margin is not very all within the scope of acceptable.
与原子吸收法比较，相对误差小于5%。
Compare this method with AAS, its relatively error were less than 5%.
对于给定的一组冲激响应数据，我们使用了几种IIR滤波器设计方法与之拟合，并对这几种设计方法的误差进行了比较。
For a set of impulse response data, we use several IIR filter design methods to fit them, and give the comparison results through these methods.
应用推荐