补偿电缆，螺旋形电缆，耐温电缆。
Compensating cables, Spiral cables, Temperature-resistant cables.
分析了发电机组中频加载掉电压故障发生的原因，提出了电缆压降补偿装置调整方法。
Analyzed failing cause of mode-frequency to load voltage drop for generating set, provided regulated method of cable voltage-drop compensation device.
由于电缆的充电功率比普通架空线路高一个数量级，如何进行无功补偿是一个需要认真研究的课题。
As charging power of cable is about one order of magnitude higher than general overhead line, how to compensate reactive power is a new subject to us.
该电缆采用了对环境的压力补偿管。
The cable incorporates a tube for compensation of the ambient pressure.
介绍了用容性电流补偿法测量xlpe电缆的阻性电流的基本原理。
The basic principle of resistive current passing through XLPE power cable measured by capacitive current compensation method is introduced.
动态电压恢复器采用单向馈能电路结构，可以在能量单向流动的情况下，实现对因电缆压降而产生的电压暂降或暂升的持续补偿。
The dynamic voltage restorer is designed as unilateral energy flow equipment which can compensate continuous voltage sag or swell resulted from the voltage drop of power cable.
介绍了在传统高抗补偿间隙经验公式的基础上，通过对射频连接器中绝缘子设计方法的改进，降低了电缆组件的VSWR。
On the basis of empirical formula, the improvement on the design method of the insulator for RF connectors is made, resulting in the VSWR of the cable assemblies reduced.
少数情况下会出现的过补偿不会影响电缆和设备的安全。
In few cases overcompensation may occurred, but no matter to the safety of cable and installation.
由于开关卡和互连电缆引起的热电效应偏移电压可采用一个短路通道来建立一个零参考，从而进行补偿。
The thermoelectric offset voltage due to the switch card and the interconnecting cable may be compensated for by using a short-circuited channel to establish a zero reference.
自动信号补偿(asc)功能，没有DIP开关设置必要的补偿高达150之间的KVM控制台模块和适配器电缆米的距离。
Auto Signal Compensation (ASC), no DIP switch setting necessary to compensate for distances of up to 150 meters between the console module and KVM adapter cables.
结果表明，在高温超导电缆分相电流差动保护方案中必须考虑电容补偿；
Simulation results show that it is necessary to consider capacitance current compensation in the phase-splitting current differential protection scheme for HTS power cable;
其目的是对井下失真信号在地面进行软件补偿和校正 ，以克服电缆、温度等原因造成的信号失真。
The self adaptive filter can reshape downhole signals, and the distorted signals are compensated and rectified by software on surface.
补偿在温度变动时电缆中的损耗。
Compensation for changes in loss as a cable's temperature varies.
具有焊线长的自动补偿功能，焊接电缆可长至100米。
具有焊线长的自动补偿功能，焊接电缆可长至100米。
应用推荐