成形载荷随着温度的升高而降低，且呈现出周期性锯齿状载荷-行程曲线。
As the temperature rises, forming load decreases, and the curves of load-stroke shows serrated periodicity rule.
文中根据路线允许最低车速和载重车的加减速行程曲线，用图解法确定爬坡车道的长度。
According to the lowest driving speed allowed by the routes and the stroke curve of add-substract speed of the trucks, we have determined the length of climbing roadway with the graphic method.
用有限元方法分析了一种圆柱疏圈螺旋弹簧的压缩变形过程，获得了弹簧的力学参量分布、载荷-行程曲线等结果，包括了弹簧发生塑性变形的情况。
The compression process of a cylindrical-helical spring is analyzed. Distribution of the spring's mechanical parameters and load-distance curve are achieved. Plastic deformation is included.
用三维有限元数值模拟软件DEFORM-3DTM进行了数值模拟研究，得到了锻造载荷-行程曲线以及整个成形过程的应力和应变分布等，并与传统的均匀加放余量法进行了比较。
At the same time, 3D-FEM simulation of the whole process was performed using DEFORM-3DTM software. And the load-stroke curve, effective stress and strain distribution, and so on were obtained.
作者利用一种新型优化算法——遗传算法优化短行程控制曲线，解决了传统方法难以解决的优化问题。
The curve of short stroke control which can , t be optimized with conventional methods was optimized with a new optimization algorithm—genetic algorithm.
使用软件MATLAB6.5进行计算，并绘出凸轮行程、速度、加速度随时间的变化曲线。
The software MATLAB6.5 is used to calculate and draw the curves of travel, velocity and acceleration to time.
本文针对比例阀缸系统，提出了用理想曲线实现液压缸的全行程任意点的缓冲定位问题。
Based on a proportional valve-hydraulic cylinder system, this paper puts forward the problem of implementing cushioning and positioning at any point in full-stroke by using ideal curve.
结果表明，下行程床层压降流速曲线的规律一致，流化时床层压降趋于稳定；
The results indicated that the pressure drop exhibited a plateau when the flow rate decreased.
行程结束，收货人揭去开启封，打开记录器，就可以得到运输温度——时间变化曲线图，方便现场判定运输情况。
At the end of the trip the receiver breaks the tamper-proof seal, opens the instrument, and removes the chart of in-transit temperature conditions.
行程结束，收货人揭去开启封，打开记录器，就可以得到运输温度——时间变化曲线图，方便现场判定运输情况。
At the end of the trip the receiver breaks the tamper-proof seal, opens the instrument, and removes the chart of in-transit temperature conditions.
应用推荐