这里描述的节气门体组件使用的铝铸件。
Throttle Body Assemblies described here use an aluminum casting.
介绍了电控发动机节气门体的三种类型及特点。
Three types and their properties of gas valves of electronic control automobile engine are introduced.
节气门体包含横跨镗孔、用于安装节气门轴的轴承。
The Throttle body contains bearings for mounting the Throttle Shaft across the bore.
节气门体有一个节流孔和IACV，以满足发动机怠速气流要求。
The Throttle body has a by pass hole and IACV for meeting the idle airflow requirement of the engine.
节气门体，同时就节气门体的进气系统的一部分，控制适当的气流流动到发动机的燃烧室。
Throttle body. The throttle body is the part of the air intake system that controls the amount of air flowing into an engine's combustion chamber.
连续节流调节装置采用了位于汽车节气门体就近汽车或引擎，以及油门踏板离汽车或引擎远程。
A continuous throttle regulation device employs a motor throttle body located proximate to a motor or engine, and an accelerator pedal located remote from the motor or engine.
节气门体之间通常是位于空气滤清器箱和进气歧管，通常是位于大规模气流传感器。冷空气摄入量和它如何运作的。
The throttle body is usually located between the air filter box and the intake manifold, and it is usually located near the mass airflow sensor.
建立了电子节气门体的数学模型，并以此被控对象在MATLAB/SIMULINK中设计并验证了改进型PID与变滑模控制器算法。
A mathematical model was set up for the ETB system. Based on it, an improved PID control algorithm and a varying sliding mode control algorithm were proposed and verified in MATLAB/SIMULINK.
建立了电子节气门体的数学模型，并以此被控对象在MATLAB/SIMULINK中设计并验证了改进型PID与变滑模控制器算法。
A mathematical model was set up for the ETB system. Based on it, an improved PID control algorithm and a varying sliding mode control algorithm were proposed and verified in MATLAB/SIMULINK.
应用推荐