分析了节径振型和节圆振型间的关系和出现规律。
The relationship between the vibration modes of node-diameter and node-circle and the law of their emerging are investigated.
此外，这种差异也存在于节径增加和节径减少阶段。
Moreover, differences also exist between the pitch radius increasing phases and pitch radius decreasing phases.
计算结果表明，几何非线性使薄壁圆柱壳产生硬化，其非线性频率升高，并同时讨论了线性、非线性频率与节径数及初始位移之间的关系。
Results show that nonlinear frequencies increase with effect of large geometric deformation taken Relationships among linear frequencies, nonlinear frequencies and initial displacements are discussed.
从乌节路向外行，就到了滨海湾。滨海广场、莱佛士城市购物中心、新达城购物中心，美年径购物中心聚集于此。
Away from Orchard Road, there is Marina Bay with its dazzling collection of shopping and dining options in Marina Square, Raffles City shopping Centre, Suntec City Mall and Millenia Walk.
实测任何相邻的两个齿间的径节值与理论径节值的偏差。
The deviation between actual measured pitch value between any adjacent tooth surface and theoretical circular pitch.
互相啮合的直齿圆柱齿轮，必须具有相同的径节。
径节螺纹种数与范围。
用运动学方法分析了等速万向节外套缩径模具的可行性。
This paper analyzed the feasibility of the ironing die of the outerace of the Constant Velosity Joint (CVJ) with kinematics.
本文叙述了填充因子与电缆参数(股数、股径、节距和截面尺寸)之间的关系。
An account is given of the relationship between the packing factor and the cable parameters, which include the number of strands, strand diameters, twist pitch and dimensions of the cable.
大熊猫咬节平均长度与粪便宽径存在显著的回归关系。
Significant regression correlation exists between fecal width and average length of bamboo stem fragments in feces of the giant panda.
各年龄组椎管矢径无明显差异；L4-S1节段15岁以上各组椎管横径大于以下两组（P<0.05）；
SD of all groups was not obvious different in L4-S1 segments, TD of every groups above 15 years old was larger than that of two groups below(P<0.05);
本文在高速滚齿机上，利用遥测应变仪，测定了工件材料，进给量，切削深度，切削速度，齿轮齿数及螺旋角等对力矩的影响，并得出径节为8时的力矩公式。
This paper presents the information of the effect, measured with a tele-strain-meter, of work material, feed, cutting speed, depth of cut, number of teeth and helix Angle etc.
本文在高速滚齿机上，利用遥测应变仪，测定了工件材料，进给量，切削深度，切削速度，齿轮齿数及螺旋角等对力矩的影响，并得出径节为8时的力矩公式。
This paper presents the information of the effect, measured with a tele-strain-meter, of work material, feed, cutting speed, depth of cut, number of teeth and helix Angle etc.
应用推荐