介绍了膜的性能要求和设备技术规范。
Introduced the membrane performance requirement and the equipment technology criterion.
钝化膜的性能得到了改善。
介绍了多种光学膜的性能。
This paper reports the performance of many kinds of optical film.
讨论了各种复合条件对膜的性能的影响。
The relationship between performance and conditions of membrane preparation were discussed.
通过超滤实验对所得膜的性能进行了评价。
The performances of these membranes were assessed in ultrafiltration experiment.
采用碱液清洗方法可以使膜的性能得到恢复。
The UF properties of PES C membrane could be recovered by the method of cleaning with NaOH Solution.
简要介绍了导电涂膜的性能特点和基本工作原理。
The characteristics and principle of conductive coat are expounded in brief.
结果表明此膜的性能与PVA均质膜变化规律相似。
The result shows that this membrane is similar to PVA dense membrane.
对荷电膜的性能，特别是流动电位进行了测定和讨论。
Some of the properties of the charged membranes, especially the streaming potential, were discussed.
研究揭示了在谐振挤压运动周期内挤压膜的性能变化。
The performance of squeeze film such as the variation of the pressure distribution and the air damping load were analyzed.
文中对木薯淀粉改善可食性羧甲基纤维素膜的性能进行研究。
The research on cassava starch improving properties of carboxymethyl cellulose films was studied.
采用椭偏仪、透射电镜等对所制得的多层膜的性能进行了研究。
The properties of the multilayer films were studied with ellipse-polarization-light thickness measurement and TEM.
通过IR、TG、防潮试验、接触角测试研究了共聚物膜的性能。
The properties of the copolymer were studied by IR, TG, moisture-protection and contact Angle measurements.
研究了由天然多糖—纤维素与甲壳素细化混合而制得膜的性能。
The mechanical properties of films made from the suspensions of blended natural polysaccharides, cellulose and chitosan, are studied.
此外，超微胶乳涂膜的性能与单体配比、加氨量和剪切时间都有关。
The performance of micro-latex membrane was affected by the monomer ratio, the amount of ammonia and shearing time.
膜生物反应器性能的好坏，在相当大的程度上取决于所采用的膜的性能。
The performance of a MBR depends upon behaviors of the used membrane to much great extent.
磷化膜的表面形貌对研究磷化液的配方和磷化膜的性能都有重要的作用。
It is important to study on the surface shape of phosphating film for the components of the phosphating solution and the performance of phosphating film.
对面漆塑料保护膜的性能、工装设备、实施工艺等方面进行了详细的论述。
This article provides detail exposition on respects of protective film's performance, tooling facilities, assembling pro - cess and so on.
综述了化学镀镍层黑化工艺方法，影响膜层黑度的因素以及黑膜的性能特点。
Blackening processes for electroless nickel deposits are reviewed. Factors influencing the shades and properties of the layer are described.
随着二氧化钛的不断加入，粒子发生团聚现象，导致杂化膜的性能开始下降。
But with particle amount increasing, agglomeration would happen which leading to decreasing of the hybrid membrane performance.
为了改善DLC膜的性能，掺金属的类金刚石薄膜从而成为人们研究的重点。
In order to improve these properties of DLC films, metal doped DLC films have been becoming an important topic of people's study.
本文概述了彩色不锈钢的应用前景和不锈钢着色原理，着色工艺方法及色膜的性能。
The application prospect of colored stainless steel, principle and the method of its surface—coloring are discussed.
结果表明，壳聚糖的加入，改善了共混膜的性能，且两共混膜成分之间有良好的相容性。
These results indicated that the film's properties were improved when the chitosan was added, and the two film-forming components were compatible.
阐明了电解着色液中组分的作用和电解参数对着色的影响。测定了着色液和着色膜的性能。
Both the function of components of the electrolyte and the effects of the electrolytic parameters on electrolytic colouring were elucidated.
研究了一种新型水显影的感光树脂丙烯酸酯酚醛树脂季铵盐的溶解性、光交联性及交联膜的性能。
The properties of acrylic phenolic resin containing quaternary ammonium salt groups (APRQA), a new type water developable photosensitive resin, were investigated.
效果是改善膜的性能（即降低污染率）和一种手段，更好地污染控制在高炉膜生物反应器的过程。
The effect was improved membrane performance (i. e. lower fouling rates) and a means for better fouling control in the BF-MBR process.
通过对PVDF树脂分散和稳定性的研究，溶剂体系和改性树脂对涂料和涂膜的性能有较大的影响。
The research on the dispersibility and stability of PVDF shows that the solvent system and modified resin have greater influence on the performance of the coatings and film.
研究了影响生物可降解多功能医用膜气雾剂的成膜的因素以及所得膜的性能以及气雾膜的止血效果。
The aerosol of biodegradable multi-function film were prepared, whose properties, affective factors and hemostasis effect were studied.
光引发剂是紫外光固化涂料的关键组分，它对光固化涂料的光固化速度和固化膜的性能起主要作用。
As an important component of UV-curing system, the photoinitiators have significant effect on curing rate and film function of UV-curing.
光引发剂是紫外光固化涂料的关键组分，它对光固化涂料的光固化速度和固化膜的性能起主要作用。
As an important component of UV-curing system, the photoinitiators have significant effect on curing rate and film function of UV-curing.
应用推荐