探讨了聚乙烯醇复合膜的形成机理。
The formation mechanism of this kind of PVA composite membranes was discussed.
探讨了镁合金上磷化膜的形成机理。
The forming mechanism of phosphate coating on magnesium alloy was discussed.
讨论了氧化膜的形成机制。
Finally the oxidation formation mechanism under different oxygen pressures was discussed.
它们能阻碍膜的形成。
研究人员表明镓能够杀死微生物，阻断被膜的形成。
The researchers showed that gallium killed microbes, and prevented the formation of biofilms.
另外探讨了钝化膜的形成机制及一次钝化液的调整和维护。
In addition, the formation mechanism of passivation film, the adjustment and maintenance of passivation solution were also discussed.
在DAD的早期，可见在肺泡的内表面有肺泡透明膜的形成。
In early DAD, there are hyaline membranes, as seen here, lining alveoli.
这种增生膜的形成主要包括细胞的增生和细胞外基质的沉积。
The process contains the proliferation of cells and the accumulation of extracellular matrix components.
目的探讨人工晶状体植入术后瞳孔前膜的形成机制与处理方法。
Objective To discuss the formation of frontal membrane of pupil and its treatment after embedment of artificial lens.
岩石风化、磨损的粒子和溶解的离子为硅膜的形成提共了物质来源。
Rock weathering, wore grain and dissolved ion provide the glaze formation with material sources.
生物膜内细菌之间存在的信号传导对生物膜的形成及其毒力具有影响。
The signal transduction existed between the bacterium has an important effect on the formation and virulence of bacterial biofilm.
对饮用水系统中生物膜的形成和影响生物膜形成的各种因素进行了阐述。
The formation of biomembrane for drinking water system and the effective factors are summarized in the paper.
探讨了正丁胺等离子体聚合膜的形成机理和传感器主要检测条件的影响；
The mechanism of the formation of PPF and the effects of the main experimental conditions are discussed respectively.
结论：细菌生物被膜的形成与治疗研究对肺部感染的防治有可观的前景。
Conclusions: the formations and treatments studying of bacterial biofilm have bright future in the preventment and treatment of pneumonia.
在这一研究的基础上，本文对滑动摩擦转移膜的形成提出粘着转移机制。
Based on this study, a adhesive transfer mechanism is proposed for the formation of transferred films during sliding wear in this paper.
分析了金属膜在合成立方氮化硼过程中的作用，提出了金属膜的形成机制。
The functions of the metal films have been analysed, and the formation mechanism of the metal film has been put out.
分析了氧化膜的形成过程、动态变化及脱落原因，并提出了控制方法和措施。
The formation process, dynamic variation, deciduous causes of oxide film of work roll are analyzed, and the control methods have been put forward.
对蒸发状态下水平螺旋槽管管外壁面升膜的形成机理和流动特性进行了研究。
The mechanism of the formation of the rising liquid thin film and its flow characteristics on the fluted surface of a horizontal tube was investigated.
目的探讨骨髓干细胞来源的星形胶质细胞是否参与脑损伤后胶质界膜的形成。
Objective To investigate the involvement of bone marrow stem cell-derived astrocytes (BMDSCs) in the formation of glia limitans after brain injury.
实验发现，机械打磨促进了电极表面缺陷位置的增加，有利于聚吡咯膜的形成。
It was found that mechanically abrading facilitates the increase of defect sites and contributes to the formation of polypyrrole films.
结果表明，通常有八种因素影响常温磷化膜的形成、外观、膜重以及耐蚀性等。
The result shows that there are eight kinds of factors, commonly, affecting the formation, the appearance, the weight and the corrosion resistance of the phosphating films.
根据磷化膜的形成原理，介绍了油管接箍在磷酸盐溶液中的工艺处理过程和检验方法。
On the principle of phosphate coating formation, the paper introduces the inspection method and the process procedure of oil pipe coupling in the phosphate solution.
铬降低了氧化膜内的铁含量，提高了初期氧化膜的保护性，从而促进选择性氧化铝膜的形成。
During the initial stage of oxidation, Cr decreased Fe content in the oxide scale, by which the selective oxidation of Al was promoted.
探讨了一种新型水基憎水剂的制备和成膜工艺，并分析了预处理金属表面超憎水膜的形成机理。
The preparation of a new kind of water-based hydrophobic agent and the mechanism of forming super hydrophobic film on pretreated metal surface are studied.
目的：探讨变形链球菌对表面涂有不同超疏水纳米膜的羟基磷灰石片的黏附和早期生物膜的形成。
Objective: To examine the adhension and formation of the dental biofilm by sreptococcus mutans on superhydrophobic nanometer film.
同时，分析认为这种氧化膜的形成与金属炉料、铸造辅料的洁净度不够以及熔炼、浇注不合理有关。
The low purity of furnace charge and accessories and the improper smelting and pouring crafts were regarded as the formation reason of the oxide film.
概述了穿孔顶头表面氧化膜的形成、结构、性质、作用，在穿孔过程中的变化及其对顶头使用寿命的影响。
This review focuses on various aspects of piercing plug surface oxide film, including formation, compose, property, effect, transformation in the piercing course and the influence of plug's life.
加入适量的稀土可以促进金属表面钝化膜的形成，并能减少异质相的存在，因而能有效地提高喷焊层的耐蚀性能。
Adding proper amount of rare earth element can accelerate the formation of passive film, and eliminate the heterogeneity in the spraying layers, so the erosion resistance can be improved.
结论人工晶状体襻不完全睫状体沟内固定是前膜形成的因素之一，而囊袋内固定人工晶状体则可减少人工晶状体前膜的形成。
Conclusion Ciliary sulcus fixation of IOL haptics is one of the predisposing factors for membrane formation on IOL while capsular bag fixation may reduce that.
结论人工晶状体襻不完全睫状体沟内固定是前膜形成的因素之一，而囊袋内固定人工晶状体则可减少人工晶状体前膜的形成。
Conclusion Ciliary sulcus fixation of IOL haptics is one of the predisposing factors for membrane formation on IOL while capsular bag fixation may reduce that.
应用推荐