像多数的高级比赛用帆一样，船帆由双层聚酯纤维膜组成，内部填充碳纤维以增加强度。
Like most advanced racing sails, they are a sandwich of polyester film sheets with a filling of carbon fibers providing strength.
实验结果还表明，膜内残余应力的存在降低了剥离强度。
The effect of the residual stress on the peel strength P/b is discussed.
白板纸强度较大，可以不覆膜，因此，成本比较低，是一种比较实惠的手提袋。
The strength of large white paper, can not covered, therefore, the cost is relatively low, is a relatively affordable handbag.
在膜生物反应器中使用聚丙烯中空纤维膜材料的膜组件，可以解决以往其它材料寿命短、强度低、易污染等问题。
The application of polypropylene membrane in MBR could resolve the problems of short life span and low strength that arc usually possessed by other material of membrane.
讨论了转光膜荧光强度与膜厚度的关系及光谱校正问题。
Dependence of intensity on thickness of LCFF and fluorescence spectra correction are investigated.
因平整度、强度不再累述，而因含水率对涂膜的影响较大，故对其测定做介绍。
Because the roughness and intensity will not described again and concrete moisture greatly affect the paint film, the measurement of concrete moisture content and roughness should be introduced.
建筑腻子聚合物粉末能在冷水中再次分散溶解，其官能团能与水泥水化产物及填料发生物理化学反应，形成具有一定力学强度的膜。
The polymer powder for building putty can be dispersed in water, and react with hydrate product of cement and stuffing, form a kind of composite membrane with a certain mechanics intensity.
分析了覆膜砂在热作用下对型砂强度、断裂表面和变形的影响。
Effects of heat performance on strength? Fractures and bending of coat sand were analyzed.
利用压力爆破技术测量了圆形金刚石膜的断裂强度。
The fracture strength of circular diamond film was measured by a burst pressure technique.
介绍了涂膜拉伸强度、断裂时的延伸率，防碳化效应特性试验以及弹性外墙乳胶涂料施工应用技术。
Tests on film tension strength, elongation rate at breaking, anti carbonation effect etc. and applied technique of elastomeric latex coating for exterior wall are described.
该膜的抗张强度和断裂伸长率则明显地依赖于辐射剂量和聚合物的混合比例。
Their tensile strength and elongation at break were obviously dependent on irradiation dose and blending ratio of the polymers.
另外，实验也考查了PV A含量、交联剂尿素的用量对涂膜耐溶剂性、剥离强度以及结构的影响。
The influences of PVA content and cross linking agent on solvent (resistance), peeling strength and structure were also studied.
将护膜覆在图片上，使图片的强度及表面的耐磨性提高。
Put the protect film on the image, increase the images intensity and surface wear resistance.
通过CMC浓度可以调节微胶囊的膜厚和机械强度。
The thickness of membrane and mechanical strength of microcapsule could be regulated by varying the CMC concentration in polyanion solution.
以马铃薯淀粉为主要原料，通过制膜机制成了具有一定机械强度的可食性淀粉膜。
The edible starch films with some intensity is made of potato starch by film machine.
也指出了提高膜基结合强度的途径。
The way to increasing bonding strength of films is also discussed in this paper.
文通过在制备增强型微孔滤膜时，改变配比中增塑剂的种类及含量，然后对膜的外观、强度、流量进行考察。
The reinforced microfiltration membrane was prepared by changing the kind and content of plasticiser and, then the appearance, strength and flow of the membrane were lion investigated.
同时，分析了电解系统温度条件以及沸水封孔工艺对强化铝绝缘膜的物理性质和电绝缘强度的影响。
At the same time, the influences of temperature condition in electrolysis system and sealing method with boiling water on the film's physical quality and electric insulating intensity were revealed.
粗糙表面的晶粒间易产生V形口，导致应力集中，降低了膜的断裂强度。
Rough surface is easy to generate V shape of stress concentration, which reduce fracture strength.
采用PVDF材料，在目前超滤膜所用制膜材料中，PVDF化学稳定性最好，耐污染，强度高，是综合性能最好的膜材料。
In the current UF membrane materials, PVDF is the best membrane material with chemical stability, anti-pollution, high strength, and best overall performance.
壳聚糖涂膜能明显降低甜玉米的呼吸强度和乙烯产量，1.0 %壳聚糖的效果明显优于0 . 5%壳聚糖。
Coating sweet corn with chitosan reduced the respiration rate and ethylene production, with greater effect at 1.0% than 0.5% chitosan.
同时通过对比试验研究了低强度的超声波对膜污染防治作用及其在膜-生物活性炭反应器中对生物过程的强化作用。
And the effects of ultrasonic irradiation at low intensity in BACMR on the enhancement of biological action and membrane pollution control were investigated through parallel experiments.
开发新的膜—基界面结合强度定量检测技术是目前薄膜技术科研人员普遍关注的热点问题。
The development of the better technique to characterize the bond strength of film-substrate interfacial is a hot topic that is concerned at large by film researchers.
研究了胶原蛋白膜的抗张强度和断裂伸长率与膜中各组成成份含量之间的关系。
The relationship of the tensile strength, elongation at break of the collagen film and the contents of each components were studied.
结果表明，与聚偏氟乙烯膜相比，改性膜的热稳定性和机械强度均有所提高。
The results show that the thermal stability and machine intensity were improved compared to Polyvinylidene Fluoride membrane.
本文采用一种简便而有效的研究方法，研究了三元组分对液膜强度的影响。
This article puts forward a simple and effective studying method and studies the strength of water film influenced by chemicals in producing sewage by the ASP-flooded.
提出一个利用多层膜小角X射线衍射谱衍射峰积分强度计算多层膜界面粗糙度的公式。
A simple formula for calculating the interfacial roughness of multilayer by using the small Angle X ray diffraction curves of the samples is given.
通过力学分析，得出弧形挑膜齿材料必须满足的强度要求。
The strength requirement of the arc spring-finger material contented has been attained by mechanics analysis.
一种是较低热负荷下的单一的微槽内三相接触线附近薄液膜区域中薄液膜的高强度蒸发换热机制（纯蒸发模式）；
One of them is pure evaporation heat transfer model in the extended thin film region near the triple-phase contact line of vapor-liquid-solid at lower input heat flux.
一种是较低热负荷下的单一的微槽内三相接触线附近薄液膜区域中薄液膜的高强度蒸发换热机制（纯蒸发模式）；
One of them is pure evaporation heat transfer model in the extended thin film region near the triple-phase contact line of vapor-liquid-solid at lower input heat flux.
应用推荐