施工完毕后，希望水泥能尽快硬化，产生强度，所以终凝时间不宜太长。
After the completion of the engineering project, the hope cement hardening, as soon as possible to produce strength, so the final setting time shoulds not be too long.
硅酸盐水泥的初凝时间不得早于45分钟，终凝时间不得迟于390分钟。
The initial setting time of Portland cement shall not be earlier than 45 minutes, final set time not later than 390 minutes.
结果表明：（1）高钙灰的掺入改善了胶砂的工作性，降低了标准稠度用水量，延缓了胶材的初终凝时间；
The results show: (1) with high calcium mixing, concrete workability was modified, the water quantity needed for standard consistence decreased, initial and final setting time increased;
由于对顶板防水功能的要求很高，经多方案比较，决定选用初凝时间长、终凝时间短、利于大面积作业的高分子益胶泥防水技术。
Because the high demand on the waterproof function of roof high polymer easy plaster waterproof technology is chosen by several plans comparison.
半水石膏凝结硬化很快，其初终凝时间为6 ~30分钟，可操作时间只有5 ~10分钟，往往不能满足石膏基材料的成型与施工的需要。
Setting time of gypsum plaster is very short, usually only 6 ~ 30 min, and operation time is only 5-10 min, which cannot satisfy the practical plastering and construction of gypsum-based material.
半水石膏凝结硬化很快，其初终凝时间为6 ~30分钟，可操作时间只有5 ~10分钟，往往不能满足石膏基材料的成型与施工的需要。
Setting time of gypsum plaster is very short, usually only 6 ~ 30 min, and operation time is only 5-10 min, which cannot satisfy the practical plastering and construction of gypsum-based material.
应用推荐