新型雷达可更换的板级电路复杂、数量多。
In the new type of radar, there are many complicated replaceable board-level circuits.
核电站1e级电路线槽系统。设计，安装和鉴定的标准。
Raceway Systems for Class 1e Circuits for Nuclear Power Generating Stations, Criteria for the Design, Installation, and Qualification of.
此外，本文提出元件级电路设计的卡诺图方法和代数方法。
Besides, the Karnaugh map method and algebra method are presented for designing component level circuits.
第一级电路的第一输入端接收参考电压，而第二输入端接收输入信号。
The first stage circuit receiving the first reference voltage input, while the second input to receive input signals.
在混合式焦平面阵列中，探测器和读出电路的耦合通过输入级电路实现。
In hybrid focal plane arrays, the coupling between detector and readout circuit is realized by input circuit.
该信号接收器包含第一级电路、第二级电路、电流补偿电路以及偏压电路。
The signal receiver circuit including the first stage, second stage circuit, the current compensation circuit and bias circuit.
第二级电路的第一、第二输入端分别耦接于第一级电路的第一、第二输出端。
The second stage circuit of the first and second inputs, respectively, in the first stage circuit coupled to the first and second output.
偏压电路依据参考电压来偏压第一级电路与电流补偿电路，并设定电流补偿电路的偏压。
Bias circuit according to the reference voltage to bias the first stage circuit and the current compensation circuit, and set the bias current compensation circuit.
系统中采用线性光偶和隔离电源，使前级放大电路和后级电路隔离，保证了系统的安全性。
The EMG preamplifier circuit and other circuits are isolated by high-linearity octocoupier and isolated power that reject the industry interference and improve the security of the system.
设备设计师能通过审慎地选择输入输出级电路的拓扑和共模阻抗来最小化失配或“非平衡”的效应。
Equipment designers can minimize the effects of these mismatches or "unbalances" through judicious choices of input and output stage circuit topologies and common-mode impedances.
结果表明，该方法诊断准确性高，比其他方法更为快速有效，较好地解决了雷达可更换板级电路的故障诊断问题。
The diagnosis result showed that the fault diagnosis method is superior to others and can accurately locate fault, which can solve the problem in replaceable board-level circuit diagnosis of radar.
采用编程仿真的方式，对单级电路和多级电路分析后，提出了晶闸管开关最佳接入时刻为被短接电容电压为零时；
By programming simulation, the single-grade and multi-grade circuits are analyzed, and it is the best moment for thyristor to switch on when the voltage of capacitor to be shorted is zero.
行激励级电路的设计是完全为行输出级服务的，它实质上是行输出级电路设计的一个重要而不可分割的组成部分。
The design of horizontal driving circuit serves completely the performance of horizontal output stage and it is actually an important and inseparable part of the horizontal output circuit design.
最优设计结果使开关调节系统的增广ISE指标最小以及功率级电路重量最小，并满足所有静态和动态性能要求。
The optimum design results in a minimum augmented ISE index of the regulator system and a minimum weight of the power stage satisfying all the static and dynamic performance specifications.
为了快速诊断板级电路故障，提出了采用分类的粗糙集-神经网络-专家系统的混合系统实现雷达装备的故障诊断。
To diagnose the board-level circuit fault rapidly, we put forward a hybrid system of rough set, neural network, and expert system for fault diagnosis of radar equipment.
本文提出了一种采用两级电路实现的地址变化探测器。与传统地址变化探测电路相比较，该设计显著提高了SRAM的抗噪声、抗干扰能力。
The SRAM use a new design of two stage address transition detector to filter out the Unwanted chip select glitches when the SRAM is asynchronously operated.
这证明了天线，无线电芯片，控制电路，和微米级的光源可以被集成在隐形眼镜镜片上，并且在眼睛上正常工作。
This verifies that antennas, radio chips, control circuitry, and micrometre-scale light sources can be integrated into a contact lens and operated on live eyes.
石墨烯可能成为纳米级的“电子电路试验板”，希恩说。
Graphene could be a sort of nanoscale "electronic breadboard", says Sheehan.
而且一个研究团队组建了一台拥有定制的集成电路的超级计算机，定制的集成电路极大地提高了蛋白质折叠计算的速度，允许在毫秒级的时间精度上进行仿真。
And one research team built a supercomputer with customized integrated circuits that dramatically speed protein-folding calculations, allowing simulations on the time scale of milliseconds.
作为纳米级存储电路及相似设备的一项候选逻辑开关，这种银触须开关具备以下几个非常有吸引力的特征。
As a candidate logic switch for nanoscale memory circuits and similar devices, the silver whisker switch has several attractive features.
论述了电爆炸导体的爆炸机制，设计了两个电爆炸断路开关的电感储能电路，通过斩波来产生一个纳秒级大电流的单触发脉冲。
Through studying the mechanism of the electric exploding, an inductive storage circuit with two electric explosive switches is designed to produce shot nanosecond pulse by chopped wave.
LOP电路设计采用VHDL语言门级描述，已通过逻辑仿真验证，并在浮点加法器的设计中得到应用。
The LOP circuit module is described in gate level with VHDL, which has passed the logic simulation and verification. It is applied to the design of floating-point adder.
本文介绍了该逻辑学和其在计算纳米级门电路的概率分布方面的应用。
This paper describes the logics and the using in computing the probability distribution of the nano-gate states.
本文介绍了一种将MOS电路级描述转换成逻辑级描述的统一方法。
An unified method for converting MOS circuit level description into logic level description is presented.
同直流信号直接耦合处理相比，交流信号耦合虽然要增设调制解调装置，但对后级信号处理电路的器件要求更低，信噪比更高。
Compared with DC coupling signal processing, it need lower requirement of signal processing circuit and have the merit of high signal-to-noise performance although it require the device of modem.
结合共射极单级放大电路的分析过程，说明了EW B软件的使用方法及对实际电子线路进行仿真的基本步骤。
Combining the analyzing process of oneway amplifying circuit, it illustrates the usage of EWB software and the basic steps of emulating the actual electron magnitudes of way.
在脉冲发生器输出端后加一级驱动电路，再接入计数器的时钟脉冲源输入端，可有效地避免通常发生在实验过程中计数器不规则的跳变。
To use the way of put a driven circuit behind the pulser, lead through the input of count clock pulse, can avoid the irregular date on the counter during experiment effectively.
寄存器传输级（RTL）描述是目前应用最广泛的电路设计描述形式。
The Register Transfer Level (RTL) behavioral descriptions are widely used in IC designs.
寄存器传输级（RTL）描述是目前应用最广泛的电路设计描述形式。
The Register Transfer Level (RTL) behavioral descriptions are widely used in IC designs.
应用推荐