在碘化钠灯照射下，电镀锌钢板的厚度明显增加。
The electrogalvanizing zinc plate were greatly increased under the irradiation of an iodinetungsten lamp.
尽管一般是通过液态锌蘸洗钢铁来镀锌，有时候也会用电解的方法，在电镀镍和铜时就通常使用电镀。
Though galvanisation is often done by dipping steel in liquid zinc, it is sometimes done by electrolysis—nickel and copper plating are normally done this way.
冷镀锌丝：是以低碳钢为芯线，通过拔丝、电镀锌工艺加工制成的金属复合材料。
Electro galvanized iron wire: Is take the low-carbon steel as the core, through the wire drawing, the electricity galvanization craft processing makes the metallic composite.
研究了稀土在硫酸盐体系电镀锌镍合金中的作用。
In this article, the effects of rare earth on Zn-Ni alloy electroplating from sulfate bath have been studied.
从事简单的滚、镀锌电镀生产。
合成了一种新型氯化钠镀锌的主光亮剂。电镀实验结果表明，在较大的电流密度范围内有较好的电镀效果。
The new main brightener was synthesized. The electroplating experimental results showed it had a fine effect in the wider range of cureet density.
为了防止铅系合金阳极引发电镀锌钢板黑变，对不同成分及不同制造方法得到的阳极进行了电化学性能研究。
The electrochemical characteristics of lead based alloy anodes with different composition prepared by different way are researched for suppressing the black patina of galvanized steel sheets.
研究了镀锌过程中镀锌工艺条件对电镀效果及镀锌石墨粉含锌量的影响。
The influences of electroplating parameters on the zinc content of zinc-plated graphite powders were analyzed in detail.
简要介绍电镀锌铁合金后的直接磷化处理工艺；讨论工艺参数对磷化膜质量的影响。
This paper briefly introduced the phosphating treatment technology Zn - Fe alloy plating, and discuss the influence of technology parameters on quality of phosphatic coating.
利用循环伏安法等方法分析了水杨酸钠。电镀锌钢板上电聚合吡咯的作用。
The role of sodium salicylate in electropolymerization of pyrrole on zincated steel was studied by cyclic voltammetry.
在发现铅是导致电镀锌钢板黑变发生的关键因素的基础上，对电镀锌钢板的黑变机理提出了锌铅共沉积假说和硫酸铅胶体膜假说；
On the basis of finding that lead is the vital factor to bring patina on galvanized steel sheets, two hypothesizes, colloid film of lead sulfate and the codeposition of zinc and lead, were employed.
用AZ 91 D镁合金制样，研究了采用碱性镀锌工艺对高纯镁合金进行电镀的预处理工艺性能。
Taking magnesium alloy AZ91D as an investigation sample, the pretreatment process for electroplating of highly pure magnesium alloy is investigated by means of basic zinc plating processing.
镀锌是应用最广泛的一个镀种，占总电镀量的60%以上。
Zinc is the most widely used a plating, accounted for more than 60% of the volume of electroplating.
而所谓电镀锌就是利用电解，在制件表面形成均匀、致密、结合良好的金属或合金沉积层的过程。
And the so-called electro galvanizing is the use of electrolysis, the formation of uniform, dense, combined with the process of metal or alloy deposit on the surface of workpiece is good.
报道了电镀锌-磷合金镀液的基液、 配体、表面活性剂和工艺条件的选择以及镀液性能的测量结果。推荐了电镀锌-磷合金的最佳工艺配方和条件。
The Paper deals with the selections of basic solution, complexant , surfactant and operating conditions of Zn-P plating. The optimum bath composition and operating conditions are recommended.
通过电镀的方法制备了不同晶粒尺寸的纳米镀锌层和微米镀锌层。
Different crystalline-sized nanometer and micrometer zinc plates were prepared by electroplating.
利用X射线衍射技术，研究了由五种不同电镀槽液所获得的镀锌层中品体的取向。
Crystallographic orientation of electrodeposited zinc in five different electrolytes were studied by means of X-ray diffraction technique.
介绍了不锈钢基材电镀镍钼合金的全部工艺过程，并讨论了前处理、锌酸盐镀锌作底层和钼合金电镀等过程因素对本工艺实施的影响。
The process of Ni-Mo plating of stainless steel is introduced in detail. The effects of pretreatment, Zincate Zn pre-plating and process factors on-the technology are also discussed.
本文叙述了化学沉淀法处理电镀锌镍合金废水所得到的污泥回槽利用问题。
This paper presented putting use of the wasted mud residue of plating Zn-Ni alloy to reclaiming bath by chemical deposition method.
研究了添加剂在电镀锌镍合金中的作用。
The effect of additives on zinc-nickel alloy electroplating was studied.
目前我司电镀的种类有：镀锌、镀镍、黑锌、黑镍、镀金、镀环氧树脂、镀铬等。
At present, our plating types are: zinc-plating, nickel-plating, black zinc-plating, black nickel-plating, gold-plating, epoxy-plating, chrome –plating, etc.
介绍了电镀锌-镍合金与电镀锌-铁合金的工艺，并突出介绍其工艺特点。
The Zn-Ni and Zn-Fe alloy plating processes and their characteristics are introduced.
碱性镀锌镀层起泡的原因很多，实际电镀中需要有针对性地排除故障。
There are so many reasons for blistering, so the trouble-shooting must be promoted pertinently to the corresponding reasons.
日本广镀金工业所是在汽车部件的电镀锌加工方面具有雄厚实力的研究开发型企业。
Hiro plating Ltd. is a research and development enterprise with advanced technique in the field of zinc plating of automobile parts.
电缆由数以千计电线组成，被高做的可拉长的钢，是抵抗腐蚀的镀锌电镀。
The cables are composed of thousands of wires, made of high-tensile steel, which are galvanized to resist corrosion.
在碘钨灯照射下，电镀锌板对偶氮染料和氯代有机物的还原降解速率倍增。
Reducing degradation rates of azo dyes and chloroorganics by the electrogalvanizing zinc plate were greatly increased under the irradiation of an iodinetungsten lamp.
幻想的测量非磁性涂层，如油漆，搪瓷，电镀，热浸镀锌钢。
Ideal for measuring non-magnetic coatings such as paint, enamel, plating, hot-dip galvanizing on steel.
镀锌片的表征条件为：使用渡锌液混合物来电镀。
The zinc electroplated strip is characterized in that it is plated with the zinc electroplating bath composition.
我们可提供对表面要求严格的高端钢卷，如电镀锌，镀铝锌，冷轧，铝板以及不锈钢。
We can provide high end, surface critical coil like Electro-galvanized, galvanized, Cold Rolled as well as Aluminum and Stainless.
冷镀锌丝：是以低碳钢为芯线，通过拔丝、电镀锌工艺加工制成的金属复合材料。
Cold galvanized wire: low carbon steel for the core-line, through the wire drawing, electrical processing made of galvanized metal composite materials.
应用推荐