电镀是一种在电镀槽通上电流使金属沉 淀在基体上的电化学过程。
Electroplating is an electrochemical process by which metal is deposited on a substrate by passing a current through the bath.
发热部是双螺旋切槽，在电流通过时可以减少其横截面积，因而发热部的阻值比冷端部的阻值大。
The hot zone is formed by cutting a double spiral slot which reduces the cross sectional area through which current flows, resulting in higher resistance than the cold end.
铝电解槽电流强化技术对挖掘现有设备产能、提高企业经济效益具有重要的现实意义。
The technology of line current raise is very important to improve the capacity of installation and economic benefits of aluminium corporations.
燃油焙烧在75KA预焙槽上的试验，可改善阴极电流分布和升温速度，减小热应力的产生，改善焙烧质量。
Fueling block experiment which is conducted on 75KA, to improve negative current distribution and rising temp as well as the production of the heat stress.
在铝电解槽阳极换块周期内连续测定阳极组的电流分布值。并采用电阻温度系数去修正测定值。
The current distribution value of anode group is continuously detected during the period of changing anode and the resistance-temperature coefficient is adopted to adjust the value.
文章研究了在电渗析硫酸钠过程中，影响电流效率和槽电压的各因素对它们的影响规律，从而找到较好的电渗析条件。
The factors that have influences on current efficiency and cell voltage in electrolysis of sodium sulfate are studied so as to find out the optimal operating conditions.
采用全电流定理，由磁场能量的计算推导出槽漏抗计算公式。
Based on full current theory, derive formula of slot leakage reactance from magnetic field energy calculation.
而氧化膜的生长和性能要受到槽液温度、持续氧化时间、合金成分、电流密度、硫酸浓度等多种因素的制约。
The growth and property of oxidized film are restricted by various factors such as tank liquor temperature, sustained oxidation time, alloy composition, current density and sulphuric acid density.
从碱性溶液中电解制备锌可以降低能耗和槽压，提高电流效率。
Electrodeposition of zinc from alkaline baths occurred at a lower cell voltage with less energy consumption and higher current efficiency.
列表说明各镀种阴极电流密度、平均装载量等数据，由此计算所需设置的镀槽尺寸。
Table listed cathodic current density and average load in different plating solutions, thereby tank size was calculated.
介绍了高电流密度自然循环复极槽的技术特点；
The technical characteristics of natural-circulation bipolar type electrolyzers with high current density were introduced.
影响铜电积电耗的因素是槽电压和电流效率。
The factors influencing electricity consumption in copper electrowinning are the voltage and current efficiency in electrolyzer.
试验中用“磁带”测量了转子槽楔电流，并用有限元法计算了转子涡流场。
The current of the rotor slot wedges are measured by magnetic test coils, and the eddy-current field of the rotor are calculated by finite element method.
铝电解槽的电能消耗率同平均电压和电流效率两个因素有关。
The energy consumption rate of aluminum electrolytic bath is related with the average voltages and current efficiency.
分析了电解槽进出口系统各主要设备杂散电流产生原因，提出了针对性的解决方案。
Causes of the stray current corrosion in inlet and outlet of the electrolytic bath were analyzed to put forward a solution.
本课题对划槽宽度与扫描速度，电流，脉宽等关系做了深入的研究，总结出各个参数与宽度的经验关系式。
The paper also research on the relation between width and velocity, current, pulse width, and summarize the formulae between width and other parameters.
对采用粉状氧化铝电解时如何提高电解槽电流效率，降低成本进行了探讨。
When powders aluminium oxide is electrolyzed, how to raise the current efficiency in electrolytic cell and reduce cost is studied in this paper.
在对单相异步电机转子槽分块与分层处理的基础上，推导了集肤效应作用下每层电流的数值计算公式。
On the basis of block building and layer building in rotor slots of single phase induction motors, the paper deduces numerical formulas for calculating layer currents under skin effect.
本文还分析了横向电流随槽斜度及接触电导率的变化规律。
The law of cross-current varying as the slot inclination and the contact conductivity is analysed.
根据质量平衡和槽电压平衡原理，提出了析气电极电流分布的数学模型。
A mathematical model of secondary current distribution for the gas-evolving electrode is presented on the basis of mass balance and voltage balance.
结果表明，所研究、开发的铝电解槽阴、阳极电流分布系统对电解槽的稳定生产起到了重要的指导作用。
This paper is a study for OLAM and the software system can develop the see-sight of user and efficiency guide the aluminum production.
同时还研究了电解过程中电极、电流密度、温度、反应时间等对反应物转化率、电流效率、槽压的影响规律。
The relationships among conversion, current efficiency and bath voltage with electrodes, current density, temperature and electrolysis time were studied.
在一定的技术条件下通过电流强化可以提高电解槽铝产量和电流效率，降低单位产品的成本。
The output and current efficiency of aluminum reduction cells can be improved by current strengthen under certain circumstances, but the cost of every product can be reduced at the same time.
赫尔槽实验可以在很宽的电流密度范围内提供电沉积过程的信息，但受到溶液搅拌的限制。
Hull cell normally provides information about the performance of a plating process over a wide range of current densities in a single experiment and has a limitation in solution agitation.
电流表是用来指示当水应该被添加到电解槽，通常经过大约80小时的驾驶。
The ammeter is used to indicate when water should be added to the electrolyser, which is typically after about 80 hours of driving.
对工作模态进行分析，给出了变换器在各个工作模态的等效电路以及谐振槽电压和电流的时域表达式。
The equivalent circuits and the expression of the current and the voltage of the resonant thank are shown with time-domain analysis.
电解槽寿命越长，电解槽的大修分摊成本越低；但随着电解槽槽龄增加，阴极压降的上升和电流效率的降低会造成吨铝电耗增加。
But the energy consumption will increases at the same time with the increase of pot life because of the increase of cathode voltage drops and of the decrease of current efficiency.
电解槽寿命越长，电解槽的大修分摊成本越低；但随着电解槽槽龄增加，阴极压降的上升和电流效率的降低会造成吨铝电耗增加。
But the energy consumption will increases at the same time with the increase of pot life because of the increase of cathode voltage drops and of the decrease of current efficiency.
应用推荐