热堆一般是个涂黑了的热探测器。
分析了超导辐射热探测器的响应率。
The responsivity of the superconducting bolometer is analyzed.
热堆一般是个涂黑了的热探测器。
红外热探测器和常接触型高温计可进行温度的混合处理。
Infrared thermo probes and contact pyrometers add temperature to the mix.
针对理想光子探测器和理想热探测器，探讨了显微热成像系统的NETD和NEED的关系。
Based on the ideal photon detector and ideal thermal detector, the relationship between NETD and NEED is studied.
奥比斯热探测器是在合适的或与大气粉尘含量高的烟雾可能暂时集中的海湾，如装载的车辆。
Orbis heat detectors are suitable in atmospheres with high dust content or where fumes may temporarily be concentrated, such as vehicles loading bays.
铁电陶瓷薄膜红外热探测器是一种无致冷的红外探测器。由于它具有很高的灵敏度，是一种很有潜力的热成像器件。
Ferroelectric ceramic thin film infrared detector is an uncooled infrared thermal detector that has great application potential for thermal imaging devices, owing to its very high sensitivity.
虽然如此，但他确实存在，分析了几十年，也未能发现任何简明易懂的理由，如：探测器有热泄漏。
Nonetheless, it is there, and decades of analysis have failed to find a straightforward reason, such as a heat leak from the probes.
热释电材料是非制冷红外探测器的关键敏感材料之一。
Pyroelectric material is one of the key sensitive materials of the uncooled infrared detectors.
从进一步的红外探测器热的是表面，少的能量，是可以进入的红外探测器的光学系统。
The further the infrared detector is from the hot surface, the less the energy is that can enter into the optics of the infrared detector.
这种方法是根据热释电探测器的工作原理，以被测物体与环境温度的差值作为参考量，根据其差值的大小确定补偿量的多少。
This new way bases on the principle of pyroelectric detector and defines the quantity of compensation according to the temperature difference between target and its surrounding.
本工作利用热丝化学气相沉积(HFCVD)法获得了(100)取向不同质量的金刚石薄膜，并制备了CVD金刚石辐射探测器。
In present work, (100) oriented CVD diamond films with different quality obtained by a hot-filament chemical vapor deposition (HFCVD) technique were used to fabricate radiation detectors.
仿真结果分析证明了热绝缘结构在探测器设计中是占有重要地位的，同时说明本文所做工作是有意义的。
Analysis of the simulation result attests that the thermal isolation structure is important in the design of a bolometer detector thus endorsing the present work.
根据热释电探测器工作原理，对其使用特点进行了分析。
This paper analyzes the characteristics of the pyroelectric detector based on its working principle.
在分光型红外气体分析器（DIGA）设计原理基础上，建立了基于热释电探测器的红外气体分析系统输入输出数学模型。
The input and output mathematical model of DIGA (Dispersive Infrared Gas Analyzer) system with pyroelectric detector was established according to the design principle of DIGA.
介绍了室温非制冷型热释电薄膜红外探测器的原理和优势。
This article comprehensively describes the properties and operating principles of pyroelectric infrared detector using thin films.
基于非致冷焦平面阵列探测器的热成像系统，要求光学系统具有足够大的相对孔径。
Thermal imaging systems based on uncooled focal plane array detectors require their optical lens with a large relative aperture.
红外探测器观察的景物亮度或对比度通常很低，此时热晕对红外像质的影响比较严重。
The influence of thermal blooming on IR image quality is relative severe when brightness or contrast of the IR detector observed scenery is very low.
热释电型探测器实际是一种对温度敏感的传感器。
Pyroelectric detector is actually a sensor sensitive to temperature.
此光电转换电路适于采用热释电探测器需快速响应。
The photoelectric transformation circuit can be applied for quick-response of pyroelectric detector.
这些包括照相机，超声波，红外线和热传感器，一个测距仪传感器，温度传感器和地面探测器。
These include a camera, ultrasound, infra-red and thermal sensors, a range-finder sensor, a temperature sensor and ground detectors.
好相反，环境背景辐射对两个热释元件几乎具有相同的作用，使其产生释电效应相互抵消，于是探测器无信号输出。
Good contrary, environmental background radiation on almost two pyroelectric devices have the same role to produce a pyroelectric effect of offset each other, so no detector signal output.
该系统分别采用热释电探测器和快速响应的红外辐射计进行测量，并采取了有效的数据处理方法，提高了测试精度。
Pyroelectric detector and fast respond infrared radiometer are used in the system to carry on the measurement, and effective data processing method is adopted to improve the test accuracy.
热释电探测器为交变信号检测器件，根据这一原理，研制了一种新的激光训练系统，完全解决直射光的问题。
Pyroelectric detectors depend upon alternating signal, based on which a new kind of laser training system was developed, and the problem of direct light was solved.
结论GR- 200a热释光探测器在医用高能电子线剂量测量中有一定的实用价值。
Conclusion the practical value of GR-200A thermoluminescence detector is embodied in measurement of medical high energy electronic dose.
并根据热尾流与周围海水的平均温度差计算出红外探测器对潜艇热尾流的作用距离。
According to the difference in temperature between thermal wake and seawater, the operation range of the detector to thermal wake was calculated.
重点介绍了铁电薄膜在铁电存储器及热释电红外探测器方面的应用。
Applications of the films, especially in ferroelectric memories and pyroelectric infrared detectors are described.
理论上用一维热模型计算了探测器在激光辐照过程中温升和输出信号的变化过程，对实验结果进行了分析。
The temperature rise and output signal of PV InSb detector illuminated by CW laser were calculated with one dimensional thermal model and the experimental result was analyzed.
理论上用一维热模型计算了探测器在激光辐照过程中温升和输出信号的变化过程，对实验结果进行了分析。
The temperature rise and output signal of PV InSb detector illuminated by CW laser were calculated with one dimensional thermal model and the experimental result was analyzed.
应用推荐