热处理温度和时间会影响蛤肉的质构和色泽。
The texture and colour of Cyclina Sinensis meat was affected by the temperature and time in following sterilization.
提高热处理温度比增加热处理保温时间的作用更明显。
Heat treatment temperature influences more obviously on dissolution of acicular iron phase than heat treatment time.
另外，研究了热处理温度对镀层硬度和矫顽力的影响。
In addition, the effect of thermal treated temperature on hardness and coercive force of cobalt-boron alloy deposit was studied.
同时研究了合金成分和热处理温度对材料硬度的影响规律。
Meanwhile, the influence rule on hardness of material by component of alloy and temperature of heat-treatment was investigated.
结果表明，晶粒异常长大的择优取向依赖于热处理温度及气氛。
The experimental results indicate: The preferred orientation of the abnormal grain growth depends on the annealing temperature and atmosphere sensitively.
随热处理温度升高，界面结合强度降低，影响着材料的弯曲强度。
The strength of interface decreased for heat-treatment, which affected the flexural strength of the material.
通过DSC发现随着热处理温度的升高纤维的熔融温度范围变窄。
According to the result of the DSC test, the melting temperature range of the fiber became narrow as the increasing of heat treatment temperature.
考察了着火温度、燃料用量和热处理温度对所获得的粉体特性的影响。
The influences of ignition temperature, fuel content in the precursor gel and calcination temperature on the characteristics of as_prepared particles were investigated.
研究了不同热处理温度对爆炸焊接复合钢板结合界面组织和性能的影响。
The influence of heat treatment temperature on the binding interface morphology and properties of explosive cladding steel plate was studied.
结果表明：随着热处理温度的不同，模塑粉的结晶形态也相应发生变化。
The results showed that the state of polyimide moulding powder changed with heat treating temperature.
结果表明，热处理温度和时间对样品中的蛋白质组分均有不同程度的影响。
The results showed that the temperature and time of the heat treatment had different effect on the protein fractions.
试验结果表明，所采用的第二溶剂及热处理温度对膜分离特性有重大影响。
The results showed that the second solvent used in multiple-stage solvent-exchange technique and shrinking temperature have an important effect on separation performance.
结果表明，弯折压平交替变形后，随热处理温度的升高，再结晶形核率增加。
The results show that after alternate deformation, with the increase of heat treatment temperature, the nucleation ratio of recrystallization rises.
研究了稀土含量、热处理温度对复合材料红外辐射性能及燃油理化性质影响。
The effects of the rare earth content and heat treatment temperature on the far infrared radiation and the physicochemical properties of fuel oil were studied.
研究了热处理温度和气氛对这些CHA的烧结、热稳定性和碳酸根替代的影响。
Effects of heat treatment temperature and atmosphere on the sinter, thermal stability and carbonate substitution of CHA were investigated.
随热处理温度的提高或时间的延长，薄膜由非晶态逐渐转化为良好的晶态薄膜。
The films gradate from noncrystalline to crystalline along with the increase of heat treatment temperature and time.
研究了热处理温度和保温时间对GH4169合金晶粒长大规律和硬度的影响。
The effects of solid-solution temperature and holding time on the grain growth and hardness of GH4169 superalloy were investigated.
研究了不同热处理温度、热处理时间及不同旋转速度对薄膜形态和结构的影响。
The influence of the heat treated temperature, time and spin speed for the films structure and morphologies were studied.
分析研究了聚丙烯腈基1k碳纤维在不同热处理温度下密度及力学性能变化。
Mechanical properties and densities of 1k PAN carbon fibers with different temperature treatment are investigated in this paper.
研究了膜组成、热处理温度、甲醇水溶液浓度等对膜电导率和甲醇透过率的影响。
The effects of curing temperature, methanol concentration and membrane composition on the ionic conductivity and the methanol permeability of the membranes were investigated.
分析了热处理温度对薄膜的结构和电致变色性质的影响，讨论了薄膜的致色机理。
The effect of annealing temperature on the structure and electrochromic properties were discussed. Furthermore, coloration mechanism was discussed.
用X射线小角散射SAXS研究了光色玻璃中卤化银微晶尺寸同热处理温度的关系。
The relationship of the size of silver halide crystallites with heat treatment temperature has been studied by means of small-angle X-ray scattering (SAXS).
通过对不同温度煅烧的赤泥特性的研究，分析了热处理温度对赤泥胶凝性能的影响。
The effect of heat treatment temperature on the cementitious activity of red mud is studied in the paper through analyzing the properties of the red mud heated at different temperatures.
分析讨论了PVA的浓度、交联剂用量、热处理温度及基膜对膜蒸汽渗透分离性能的影响。
PVA concentration, amount of crosslinking agent, the temperature of heat treatment and base membrane which might affect performance of composite membranes, were also studied.
本文应用X射线透射截面形貌技术研究了氢气区熔硅单晶中氢致缺陷与热处理温度的关系。
The relationship between the annealing temperatures and the hydrogen-induced defects in floating zone silicon grown in hydrogen atmosphere has been investigated by X-ray section topography.
结果表明：热处理温度对有机硅树脂结合不烧铝碳滑板的性能、物相变化和显微结构影响显著。
Results showed that heat treatment temperatures affected the properties, phase evolution and microstructure of the specimens remarkably.
由于恰好高于低临界温度通常使过共析钢奥氏体化而硬化，所以对外层采用较低的热处理温度。
The lower heat-treating temperature of the case results from the fact that hypereutectoid steels are normally austenitized for hardening just above the lower critical point.
分析了纳米颗粒前驱体的大小、盐介质的选取、热处理温度等因素对纳米颗粒固相生长的影响。
The influence of salt medium, annealing temperature and the critical size of nanoparticles on growth process was analyzed in detail.
探讨了热处理温度、萃取条件、晶须含量、粉体粒径对偏磷酸钙产物形貌和复合材料强度的影响。
The factors influencing the morphology and strength of the samples such as heating temperature, extraction condition, crystal content and powder diameter were discussed.
研究了2a12铝合金表面镍磷合金镀层的性能及热处理温度对镀层硬度、耐磨性、磨损速率等的影响。
The article research for the properties of Ni-P coat on 2a12 aluminum alloy and the effects of heat treatment temperature on hardness, wear resistance and wear rate etc. of coat.
应用推荐