这就是温度偏高的原因。
分析了终冷段煤气温度偏高的危害及原因，并提出了处理办法。
Reasons and harm of higher gas temperature at the final cooling stage are analyzed and solutions are proposed.
前期热带海洋海表温度偏高，可能预示长江中游夏季降水偏多，反之亦然。
Maybe higher tropical sea surface temperature is an indication of excess of rainfall over the middle reaches of the Yangtze River.
讨论了超临界压力直流锅炉在启动初期应充分注意锅炉主汽温度偏高的问题。
The problem of boilers main steam temperate to be rather high in super critical pressure concurrent boiler at start-up initial stage, which should be paid enough attention to was discussed.
解决了井下空间狭窄、流体粘度大、工作温度偏高、环境压力偏大等测量难题。
It solved the measurement problem that is little under-well space, high liquid viscosity and high operation temperature.
今天的小棕棕本来是可以做得非常成功的，但是我忘了我们家的烤箱温度偏高。
The brownie I baked today supposes to be very good, but I forgot the temperature of our oven is a little bit high than the normal ones.
结果表明，钢坯的内在缺陷、加热温度偏高及加热不均匀是产生边裂的主要原因。
The results showed that the immanent quality disfigurement of billets, the heating temperature on the high side and non-uniform were the main factors to cause the edge cracking.
水电厂的推力轴瓦，已往多采用钨金瓦，它在运行中温度偏高，容易发生烧瓦事故。
Usually, tungsten bush is used to be the thrust bearing in water power plant, but it is easy burned down since its high temperature during its operation.
然而，通常热膨服系数高的封接玻璃软化温度低，而热膨胀系数低的软化温度偏高。
The soldering glass has a rather low coefficient of expansion as well as low sealing temperature.
结果表明，尖角效应引起的应力集中和热处理淬火加热温度偏高是导轨端面产生裂纹的主要原因。
The results show the stress concentration caused by acute angle effect and the high temperature are the primary cause of producing crack.
在图像增强处理技术方面，提出了自适应灰度拉伸法，实现了对本系统感兴趣的温度偏高区域的增强。
At the aspect of image enhancement technique, this paper proposed the adaptive gray-scale extension and enhanced the higher temperature region, which is important to this system.
用金相显微镜对衔铁线圈骨架的裂纹进行分析。结果表明，由于锻造加热温度偏高，材料脆化导致裂纹形成。
The electromagnet coil former was analyzed by means of metallurgical microscope. The results shows that cracks results from excessive high temperature while casting and material embrittlement.
对实际运行中存在的热管失效、热空气温度偏低、排烟温度偏高等问题进行了分析，并提出了相应的改进措施。
The heat pipe failure, lower heating air temperature, higher flue gas emission of the furnace in operation are analyzed and improvement measures are suggested.
通过对机车出现的油、水温度偏高的原因分析，找到了处理这一故障的方法，使得每到夏季频繁出现的油、水温度高的问题得到了解决，并提出了相应的建议。
By analysing the reasons for too high (temperatures) of oil and vater, we find an efficient way to solve this trouble frequently happening in summer. Some Suggestions are also proposed.
热效率和火用效率达不到设计值的原因，一是排烟温度超过设计值，二是空气系数偏高。
The low efficiency is caused by the rejection temperature exceeding the design value and the high air coefficient (oxygen content).
在非线性电阻消谐方式下，正温度系数(PTC)热敏电阻和三次谐波滤波器可以较好地解决零序电压偏高的问题。
Positive temperature coefficient (PTC) thermistor and triple frequency harmonic filter can reduce zero sequence voltage when a nonlinear resistance is used to prevent ferroresonance.
由于转炉出钢温度也偏高，实施溅渣护炉以大幅度提高炉龄比较困难。
Besides of the high tapping temperature, it is difficult for the vessels to prolong service lives remarkably by slag splashing.
结果表明 ，轮毂在径向冲击检测时开裂的主要原因是镁含量偏高 ，以及热处理加热温度高造成组织过热所致。
The results show that the wheel hub cracking during radial impact testing was caused by excessive content of magnesium in the alloy as well as the overheating of the alloy during the solution process.
结果表明 ，轮毂在径向冲击检测时开裂的主要原因是镁含量偏高 ，以及热处理加热温度高造成组织过热所致。
The results show that the wheel hub cracking during radial impact testing was caused by excessive content of magnesium in the alloy as well as the overheating of the alloy during the solution process.
应用推荐