试验结果表明，该合金流动应力随着变形温度的升高而下降，随着应变速率的增加而增加。
The results showed that the flow stress of this alloy reduced with increasing deform temperature and increased with increasing strain rate.
随着温度的升高，氧化反应速率呈降低-增高-降低-增高的规律变化，总趋势在下降。
With a dropping tendency, the rate of oxidation changes in cycles of down and up with the increased temperature.
温度升高，载溴活性炭的吸附能力略有下降，烟气中的二氧化硫对单质汞的吸附速率略有抑制作用。
The adsorption capacity of brominated activated carbon dropped slightly with temperature raising, the sorption rate of elemental mercury by SO2 in flue gas had a little inhibition action.
结果表明：随淬火介质温度的降低，淬火降温速率提高，合金的强度增加，塑性下降；
The results show that the ultimate tensile strength and yield strength of the alloys rise but the total elongation decreases as the temperature of quench medium drops.
结果表明，通过试验，表、中层水体的温度有所下降，温度降低会抑制表、中层水体中藻细胞的繁殖速率。
The results indicated that the temperature of the surface and middle-level water in reservoir dropped, and then it could inhibit the birth rate of algae cells.
纺丝原液粘度随着温度、剪切速率的增大而降低，过了临界切变速率后粘度会急剧下降，但在低剪切速率区粘度基本不变。
The viscosity dropped with the increase of temperature and shearing rate and decreased drastically over critical shearing rate, but remained almost unchanged at lower shearing rates.
在含硼中碳钢的热压缩变形过程中，应变速率一定时，随着变形温度的升高，真应力下降；
The flow stress decreased as deformation temperature increased and became higher as strain rate rises.
随升温速率的提高，生物质的最大热解速度提高，对应的峰值温度升高，最终失重率呈下降趋势。
With the rise of heating rate, the maximum decompose rate and its corresponding temperatures of biomass increases, but the final agravic quotient decreases.
在形变速率相同的条件下，随变形温度的升高，试样内部最大形变抗力及最大应力呈下降趋势。
The inner maximum resistance force and the maximum stress of the specimen decreases as the deformation temperature increasing.
随着气体流量的增大，弧梢处与弧根处的振动温度均下降，但弧梢处下降速率较快。
With gas flow rate increasing, the vibrational temperature at both tip and root decreases, but the decreasing rate at arc tip is faster than that at arc root.
随着剪切速率的提高、温度的升高、剪切应力的增大、蒙脱土的含量增加粘度均呈下降趋势；
Along with shear rate's enhancement, the temperature elevate, the shear stress to increase, the montmorillonite clay content to increase the viscosity to assume the declining trend;
峰值流变应力随着变形温度的升高而下降，且下降速率随着温度升高而降低；
The maximum flow stress decreased with the increase of the temperature, furthermore, the reduction speed decreased with the increase of the temperature.
峰值流变应力随着变形温度的升高而下降，且下降速率随着温度升高而降低；
The maximum flow stress decreased with the increase of the temperature, furthermore, the reduction speed decreased with the increase of the temperature.
应用推荐