微量元素测定试验结果。
果实损伤测定试验表明，在此处理条件下，对芦柑鲜果不会造成损害。
The fruit injury test shows that the above treating condition is not harmful to the fresh fruits.
最后，介绍了可靠性测定试验，并对某产品的测定试验结果进行了分析。
The reliability qualification test schemes are designed by non using GJB899. Finally, the reliability determination test is presented, and the determination test result of a product is analyzed.
前瞻性血小板聚集率测定试验：对照组和联用组临床基线资料无显著差异。
There were no significant differs in the baseline level or 72h value after PCI of the maximum platelet aggregation rate (MPAR) between the two groups.
本文介绍了硬齿面点线啮合齿轮传动的承载能力试验和噪声测定试验的情况。
In this article the bearing ability test of hard gear face point-line meshing gear transmission and the trial of noise test are introduced.
方法：按设立的验证试验方法，在样品中加入试验菌，测定试验菌的回收率。
Method: According to the method set up for validation, the tested microorganisms with known counts were added to samples followed by the determination of the recovery.
为了验证计算方法的正确性，还在接管部位用电测法进行了高温应力测定试验。
Besides, a high temperature stress measurement experiment was conducted at the nozzle zones by using the electric measurement method to verify the calculation correctness.
目的应用单核细胞单层试验和抗体效价测定试验预判新生儿溶血病的效果比较。
Objective To compare the prediction effect on hemolytic disease of the newborn between monocyte monolayer assay and antibody titre.
然后进行储水系统土样的试验，包括土样的渗透系数测定试验和毛细水上升试验。
Then it carries on soil sample the experiment of the storing water system, including penetration coefficient determination experiment and capillary water rising experiment of the soil sample.
采用玻片浸渍法，进行了哒螨灵与柴油或四螨嗪混用对山楂叶螨的室内联合毒力测定试验。
The allied toxicity of pyridaben and diesel oil or clofentezine were measured in laboratory by slide slip method.
用该夹具进行了一系列材料内抗剪强度测定试验，试验结果充分证明该夹具的使用效果良好。
A series of test of the internal-shearing strength of material has been made by the fixture, the outcome of the testing fully proves that the fixture achieved good results.
通过加电前后岩石颗粒的粒度测定试验，研究了外加电场对岩石骨架颗粒和粘土矿物性质的影响。
This paper tries to study how the externally applied electric field influence the properties of rock grain and clay minerals, by testing the grain size before and after applying electric current.
本文简介在鞍钢第三炼钢厂转炉上，采用国产直接定氧仪器，在线快速预报铝镇静钢中酸溶铝的测定试验。
The article briefly described measurement and examination on the on. line fast prediction of acid soluble Al in the Al-killed steel using a home made direct O_2 determinator.
通过对掺高效减水剂水泥净浆流动性及流动性损失的测定试验，研究了高效减水剂与水泥及掺混合材水泥的相容性。
The compatibility of the superplasticizer with straight cement and admixture cement is investigated by testing the fluidity loss of cement pastes containing the superplasticizer added.
本文简要介绍了MPS磨煤机旋转分离器的模化原理和第二自模化区的测定试验；使用粒子动态分析仪（PDA）测量了分离器内部族流场；
In this paper, the modeling principles of a rotary classifier used in a MPS pulverizing mill and the lest of the second self-modeling region of the classifier model are briefly introduced;
在试验中一天两次对0—80cm土壤层每20 cm处进行湿度测定。
During the experiment, moisture was measured twice a day at 20-cm intervals between 0 and 80 cm of the soil.
当然，度量意指测试，且这些指标应该在测试中根据试验测定，因为时序随设计的不同而有所不同。
Of course, measuring implies testing, and these metrics should be measured experimentally in testing, as the timings vary from design to design.
它也应在测试中根据试验测定。
这样的转换需要精心考虑方法，试验项目用于提前测定转换时间，高级设置可实现快速转换。
Such a transition comes from careful consideration of options, pilot projects to gauge conversion time in advance, and advanced setup for fast conversion.
对用粘度法测定绝缘纸的平均聚合度做了简要介绍，并对试验结果进行了分析。
The measurement on average degree of polymerization in insulation paper with viscometry is introduced, and some testing results are analysed.
通过试验来测定轮胎刚度，也就是说把轮胎的变形也考虑到课题中去。
Through testing to determine tire stiffness, ie the deformation of the tire also takes into account issues and going.
最后，对制得颗粒的物理和形态学特性进行测定，并与试验中使用黏合剂HPC的浓度进行相关分析。
Finally, the mechanical and morphological properties of the produced granules were measured and correlated to the HPC concentration of the binder used in the experiments.
基于大田土壤水分入渗试验与相关参数的测定，分析了耕作土壤入渗能力衰减过程，探讨了耕作土壤入渗能力衰减机理。
Based on soil water infiltration testing and related parameters measured in field, tillage soil water infiltration capacity attenuation process was analyzed and the mechanism was discussed.
一种直接测定的方法就是压力泌水试验。
A direct method for measuring this is the pressure bleed test.
转向系的等效刚度也需通过试验来测定。
The equivalent stiffness of steering system also need to be measured by experiment.
方法采用定量杀菌试验方法和化学测定方法在实验室进行了观察。
Quantitative germicidal test method and chemical measuring method were used to carry out laboratory observation.
方法采用定量杀菌试验方法和化学测定方法在实验室进行了观察。
Quantitative germicidal test method and chemical measuring method were used to carry out laboratory observation.
应用推荐