比较器电路也许会出现偏移量，导致触发时机的提前或是延迟。
The comparator circuit may develop offsets, causing it to trigger early or late.
在理想的情况下，当把电压表连接到一个没有电压的、阻抗比较低的电路时，电压表的读数应当为零。
Ideally, when a voltmeter is connected to a relatively low impedance circuit in which no voltages are present, it should read zero.
利用向量比较原理，得到了确定非线性电路平衡点全局渐近稳定的充分必要条件。
The sufficient and necessary conditions for the global asymptotic stability of the equilibrium point of the nonlinear circuits are obtained by vector comparison method.
通过对电路的理论分析和实验测试，并与传统的CMOS与非门比较，认为该两种ULG。
Through theoretical analysis, experiments and comparison with traditional CMOS gates, it is considered that either of the two practical circuits for ULG.
在某相位编码毫米波雷达系统中，要求很高的目标速度测量精度，因而目标多普勒频率测量电路的设计比较重要。
The design of target doppler frequency measurement circuit is very important in phase coded MMW radar system because of the high measurement precision requirement of target speed.
通过对几种电路的性能比较，提出了适合航天应用的DC - DC变换器的最佳拓朴结构。
Based on the comparison of the performances of some circuits, an optimal topology of the DC-DC converter suitable for aerospace electronic systems is proposed.
通过原理分析和电路比较，设计了性能较优的闭环波门跟踪系统方策应用于电视跟踪系统。
Through the principle analysis and the circuit com- parison, we have designed a better scheme of a closed electronic window trac- king system.
在某相位编码毫米波雷达系统中，由于对目标速度测量精度的要求很高，因此目标多普勒频率测量电路的设计也具有比较重要的地位。
The design of target Doppler frequency measurement circuit is very important in phase-coded MMW radar system because of the high measurement precision requirement of target speed.
系统调速控制是利用反馈回路中的比较电路来完成。
System is it is it is it feedback comparison circuit of return circuit finish to utilize to control rapidly to adjust.
分析了变压器的电磁关系及励磁参数，提出了变压器的等效电路另一形式，并且与现用的等效电路进行比较。
The electromagnetic relation and exciting parameters of transformer are analysed. An another form of transformer equivalent circuit is proposed and is compared with present equivalent circuit.
通过三种不同方法的比较，归纳出对于不同电路应当采取不同处理办法。
Conclude different processing method in different circuit by comparing three different ways.
对于硬件接口电路中常用的一些方法进行了简要的比较，并介绍了电平转换芯片MAX232及其应用方法。
It gives comparison among some methods which are often adopted in the interfacing circuit, and introduces a chip MAX232 of level translation and its application method in detail.
新型电流极限比较器由电流检测电路和电流比较电路两个部分组成。
This paper proposes a new current-limited comparator including current detect and current comparison circuits.
提出了一种有效的验证集成电路版图的网络比较算法。
An efficient network comparison algorithm for layout verification of integrated circuits is presented.
在每次测试第一次通电过程中，控制动作时间比较电路启动，同时数字信号处理芯片自动记录每一路的热敏电阻的动作时间数据，并进行处理。
In the first course of testing, the operating time of compare circuit is brought into play, synchronously, digital signal processor clock all the testing circuits operating time and keep these .
经过大量试验研究，对磁悬浮轴承控制系统中选定比较电路，成功地将悬轴控制在设计范围内。
Through a great deal of tests and studies, comparative circuits for the control system of magnetic levitation axletree were chosen to control the levitation in the range of design.
瞄控台自动控制器由at98c 2051、电桥和电压比较电路及数控电位器x 9241组成。
The controller of aiming control platform (ACP) is composed with AT98C2051, Voltage comparing circuit, electric bridge and digital potentiometer X9241.
硬件电路简单，可靠性高，抗干扰能力强，是一种比较理想的晶闸管触发装置。
The hardware circuit is simple, and it has strong reliance and anti-interference ability, which is a kind of ideal SCR trigger.
比较研究的结果能为各种电路拓扑的选择和优化提供借鉴指导。
The study results can offer and guide the choice and optimization of various kinds of circuit topologies.
该电力有源滤波器以主电流为控制对象，控制电路比较简单。
The filter takes the main current as a controlled object. Its control circuit is simple.
本文提出了一种在输入信号上升延迟滞的比较器电路。
This paper introduces a hysteresis comparator whose output can be delayed when the input signal is in rising time.
为了克服开环比较电路因噪声信号引起的多重触发，噪声环境中的比较电路设计宜引入正反馈采用迟滞比较电路。
In case of multiple transitions caused by noise, it is an efficient way to use positive feedback to introduce a small amount of hysteresis when designing comparing circuit.
在研究传统数字比较器的基础上，提出了一种基于CMOS传输门的开关级数字比较器电路。
A new type of magnitude circuit in CMOS switch-level is present based on the study of the traditional one.
许多文献都对这种自适应偏置技术进行了研究，然而，对于多种自适应线性化偏置电路比较和分析的文章尚未见报道。
Many papers have focused on the research of these adaptive bias circuits, but none has reported on the comparison and analysis of these bias circuits.
传感器结合单片机控制电路是目前应用比较广泛的实用电路之一。
The control circuit by sensor with SCM is one of the widely-used practical circuits at present.
电源、比较电路、负载；
The power source supplies electricity to the comparison circuit;
数模混合电路的设计流程是比较复杂的。
系统包括CCD驱动脉冲产生电路、低噪声测量放大电路、自适应比较电路、单片机控制电路以及上位机处理程序。
The system consists of driving pulse generating circuit for CCD, instrumental amplifier with low noise, MCU controlling circuit and PC program for dealing with the data conveyed by MCU.
通过对agc基本电路的分析和比较，为实际的AGC电路的设计打下了基础。
For practical purposes, this paper will be basic for the design of AGC circuits by analyzing and compare the AGC basic circuits.
通过对agc基本电路的分析和比较，为实际的AGC电路的设计打下了基础。
For practical purposes, this paper will be basic for the design of AGC circuits by analyzing and compare the AGC basic circuits.
应用推荐