而这个军事基地的主要用途就是为了进行飞机和武器系统的研发测试。
The base’s primary purpose is to support development and testing of experimental aircraft and weapons systems.
该设备无疑使我们满足快速扩展的测试需求和日益复杂的武器系统制造需求能力向前迈进。
This facility is unquestionably a leap forward in our ability to meet the rapidly expanding requirements surrounding test and production of increasingly complex weapon systems.
测试由美国导弹防御局和洛克希德·马丁公司联合举行，洛克希德·马丁公司是THAAD武器系统的主要合同商和系统集成商。
The test was conducted by the U.S.Missile Defense Agency and Lockheed Martin, the THAAD weapon system's prime contractor and systems integrator.
测试由美国导弹防御局和洛克希德·马丁公司联合举行，洛克希德·马丁公司是THAAD武器系统的主要合同商和系统集成商。
The test was conducted by the U.S. Missile Defense Agency and Lockheed Martin, the THAAD weapon system's prime contractor and systems integrator.
Alion公司将对武器系统目前的技术需求进行研究，开发关键的性能参数，从而测试系统的技术性能，对系统的设计进行检查。
Alion will research current technical requirements for weapon systems, develop key performance parameters to test the technical performance of the systems and perform design reviews on the systems.
当激光激活测试完成后，将进行激光地面火力发射，随后是整个机载激光武器系统的飞行测试。
When the activation tests are complete, ground firings of the laser will occur, followed by flight tests of the entire ABL weapon system.
这一基地主要是为实验飞机和武器系统的研发及测试提供支持。
The base's primary purpose is to support development and testing of experimental aircraft and weapon systems.
接着，结合武器系统可靠性评估软件的开发实际，进行了软件测试方面的研究工作，分析了软件可靠性的几种模型，探讨了软件可靠性的提高手段与方法。
With the practice of the software design, the software test is researched, several models of software reliability are analyzed, the methods and ways to improve software reliability are discussed.
无论是研究物体的电磁散射特性还是研制具有突防能力的隐身武器系统，RCS测试具有非常重要的意义。
RCS measurement is necessary to research the electromagnetic scattering properties of radar target as well as to design stealth weapon system.
这种武器系统于2007年成功进行了测试，击落了一颗位于500公里高度轨道的卫星。
The weapon was successfully tested in 2007 shooting down a satellite at over 500km altitude.
测试由美国导弹防御局和洛克希德·马丁公司联合举行，洛克希德·马丁公司是THAAD武器系统的主要合同商和系统集成商。
The test was conducted by the U. S. Missile Defense Agency and Lockheed Martin, the THAAD weapon system's prime contractor and systems integrator.
由于现代武器系统复杂化程度不断扩大，使得检测和维修难度增大，比如测试时间变长、维修保障费用增加。
Because the modern weapon system became more and more complexity, it will lead the fault detection and maintenance more difficult, such as the fault detecting time became long and the cost increases.
该方法有助于缩短平台的测试时间，提高武器系统的使用精度。
This method can give great help to the test and use of the platform.
该系统可更换相应炮种的机械适配器，并在计算机运行不同的程序下对不同的高炮武器系统进行测试。
The system can replace the corresponding machine-adapter of different Archibald and test the different kinds of Archibald weapon system by running different software.
分析研究了地面电磁环境特性及其对武器系统工作状态的影响，提出了地面电磁环境特性的测试原理、方法和系统。
Researches and analyzes ground environment characteristic and its influence on the work state of weapon system, provides the measurement principle, method and system.
如果发现某台仪器型号超出容许范围，则工程师会探寻超容许范围仪器对测试仪以及对最终武器系统的影响。
If a particular instrument model is found out of tolerance, however, engineers will look at the impacts that an out-of-tolerance instrument has on testers and ultimately on weapons systems.
当测量需求评估(MS10)小组的工程师确定了一种需要测试的武器系统时，他们也决定了该测试系统是否需要校准。
When engineers in the Measurement Requirements Assessment (MS10) group determine that a weapons system needs testing, they also determine if the test system needs calibration.
对于现代复杂武器系统来说，采用先进的测试仪器和测试方法是必然的。
It is very necessary to measure modern complex weapon system with advanced testing instruments and testing methods.
传统测试技术难以满足复杂的机载雷达制导武器系统的测试需求。
The traditional test technology can't satisfy the need of the test for the complicated airborne radar guidance weapon system.
本文介绍了使用双镜头狭缝摄影对某武器系统外弹道飞行姿态测试的方法及可行性分析。
The effect of empennage spread on flight attitude was analyzed and validated by flight test data.
针对导弹武器系统模拟测试方案存在的不足，提出了基于现场总线的数字化测试方案，文中从硬件和软件方面给出了惯性测量组合测试节点与 CAN 总线的接口设计。
We put forword one Check-up and control system based on CAN-bus, and introduced its whole structure, hardware collocation, software Collocation, interface-circuit and so on.
针对导弹武器系统模拟测试方案存在的不足，提出了基于现场总线的数字化测试方案，文中从硬件和软件方面给出了惯性测量组合测试节点与 CAN 总线的接口设计。
We put forword one Check-up and control system based on CAN-bus, and introduced its whole structure, hardware collocation, software Collocation, interface-circuit and so on.
应用推荐