换句话说，校验字节的监测和检测过的SONET帧的不同部分中的错误。
In other words, parity bytes monitor and detect errors over different parts of a SONET frame.
数据包被转发前需要被完全接收下来，并且计算帧校验序列，该序列值错误的包将会被丢弃。
The frame is completely received before it is relayed as the Frame Check Sequence (FCS) is to be calculated and the frame discarded if in error.
接受方和发送方必须具有相同的帧长相同的校验方式，和相同的终止位。
Receiver and transmitter devices must have the same word length, the same parity and the same number of stop bits.
使帧特性帧校验序连接指种数据封装。
HDLC specifies a data encapsulation method on synchronous serial links using frame characters and checksums.
二层的帧必须等到所有比特全部接收通过CRC(环冗余校验)验后才能被处理。
Layer2 frame cannot be processed by a receiver until all bits have been received by the receiver and a cyclic redundancy check (CRC) has been performed.
通过使用帧方式、CRC校验和选择重发纠错功能保证了协议的可靠性，该协议在一定程度上还可得到扩充。
The reliability of the protocol can be ensured by use of the frame format, CRC check, and correct function of selecting and sending repeatedly. The protocol can be extended to a certain extent.
BIP- 8执行以前的同步传输信号电平1 (STS - 1)帧的偶数奇偶校验。
BIP-8 performs an even-parity check on the previous Synchronous Transport Signal level 1 (STS-1) frame.
二层的帧必须等到所有比特全部接收通过CRC(循环冗余校验)效验后才能被处理。
A Layer 2 frame cannot be processed by a receiver until all bits have been received by the receiver and a cyclic redundancy check (CRC) has been performed.
如果CRC校验没有通过，帧将被丢弃。
帧然后基于特定分组码经编码以提供一致校验比特。
The frames are then coded based on a particular block code to provide parity bits.
网桥存储所有的帧并在校验CRC后进行转发。
The bridge stores the entire frame and verifies the CRC before forwarding the frame.
本文档介绍了位交叉奇偶校验(BIP - 8)帧检查，超过SONET (POS)的路由器接口发送的数据包。
This document explains bit interleaved parity (BIP-8) checks on frames that a packet over SONET (POS) router interface transmits.
当一个帧到达时，校验和将被验证。
论文介绍了多功能总线控制器编码器的设计，编码器有六个模块组成，分别为位控制单元、FIFO单元、帧分界符单元、数据转换单元、CRC校验单元和曼彻斯特编码单元。
The paper describes the design of encoder which is divided into seven modules: bit control unit, FIFO unit, frame delimiter unit, data conversion unit, CRC unit, Manchester encoding unit.
PLC每接收到一帧数据，对该帧数据进行异或校验，如果无误则存送到指定缓冲区，如果有误则请求重新发送。
When PLC receive one frame data, it checkout the frame. If the data is correct, it is saved in the appointed buffer. If not, PLC request the IPC resend it.
不利因素也随之产生，由于直通模式不做CRC校验，网络上的畸形和错误帧将增加。
The disadvantage is that the cut-through operation does not check for CRC errors, which increases the amount of runt and error frames on the network.
不利因素也随之产生，由于直通模式不做CRC校验，网络上的畸形和错误帧将增加。
The disadvantage is that the cut-through operation does not check for CRC errors, which increases the amount of runt and error frames on the network.
应用推荐