极点配置是广义系统研究的重要方面。
Pole placement is an important side to study generalized system.
研究了矩形广义系统的有穷极点配置问题。
In this paper, finite pole assignment problem for rectangular systems is studied.
提出了基于极点配置的混沌滑动模态控制方法。
The sliding mode control method for chaotic systems based on pole-replacement is presented.
本文给出了一种简单的极点配置自校正预测控制器。
In this paper, a simple pole assignment self-tuning predict controller is introduced.
给出多输入定常线性系统极点配置问题的一个新解法。
A new solution to the pole assignment of multi input system is proposed.
在反馈规律设计中采用了最优控制和极点配置二种方法。
And two methods of optimal control and pole disposition is used in design on feedback law.
本文提出了一种简单的多变量极点配置自校正解耦控制器。
In this paper, a simple multivariable decoupling pole assignment self-tuning con-troller has been presented.
其次提出了一种比例积分型切换超平面的极点配置设计方法。
Secondly, a method of pole assignment is put forward for designing switching surfaces of PI type.
提出一种对于带有输入延迟的离散时间系统极点配置的新方法。
A new method is proposed of pole assignment for discrete-time systems with delays at plant input.
基于反馈对消技术的应用，通过极点配置获得状态反馈控制律。
By feedback cancellation technique, a state feedback control law is obtained by pole placement.
针对线性定常系统，提出了考虑执行器故障的可靠极点配置问题。
Aiming at linear time-invariant system, puts forward the reliable pole placement problem considering actuator fault.
提出了一种新的加权极点配置方法来设计挠性系统的鲁棒控制器。
A new weighted pole-placement method is proposed to design a robust controller for the flexible system.
在此基础上，讨论多采样率数字控制系统在输出反馈下的极点配置问题。
Then the pole assignment of multirate digital control systems under output feedback is discussed.
极点配置问题的算法有多种，特别是对于多输入系统，其计算较为复杂。
This issue have manifold algorithms, especially for multi-input system, it's calculation are rather complex.
极点配置问题的算法有多种，特别是对于多输入系统，其计算较为复杂。
With various algorithms, especially for a multi input system, the technique involves a calculation.
综合式自校正PID调节器兼有相位裕度和极点配置两种设计方法的优点。
The hybrid design of self-tuning PID regulator combines the advantage of phase margin design with the advantage of pole placement design.
本文针对一类多变量系统提出了一种新的极点配置自校正动态解耦控制器。
This paper presents a new multivariable pole - assignment self-tuning dynamic decoupling controller for a class of multivariable processes.
通过适当的变换，将同时极点配置问题归结为一系列线性方程组的求解问题。
Through suitable transformations, the solution of the simultaneous pole assignment problem is resort to the solution of a number of linear equations.
基于李亚普诺夫方程的状态反馈增益算法是极点配置算法中比较常见的一种。
Lyapunov Equation based algorithm for calculating state feedback gain is a comparatively normal algorithm used in pole assignment.
外环的设计则引入自校正控制器——零极点配置控制器（含实时参数辨识）。
The outer loop's design is to use a self tunning regulator such as zero pole placement (with real time identification).
基于矩量分析，作者提供了一种求单输入线性控制系统极点配置问题的新算法。
A new efficient algorithm for the pole assignment problem of single-input systems is presented in this paper.
考虑的具体方法是将PD反馈波控制与基于极点配置法设计的模态控制相结合。
The particular approach considered is that of collocated, PD feedback wave control combined with modal control designed using pole placement.
利用LMI给出了带有不确定性扇形区域极点配置的可靠控制器存在的充分条件。
Based on LMIs, a sufficient condition for the existence of reliable control with uncertainty of pole configuration is given.
对多变量广义预测极点配置自校正解耦控制算法，进行了稳定性和全局收敛性分析。
The stability and global convergence properties analysis of the multivariable generalized predictive pole-assignment self-tuning control recursive algorithm is presented.
针对广义线性系统，提出了基于全维观测器的控制系统设计的鲁棒极点配置分离原理。
A separation principle for robust pole assignment in the full-order observer-based control system designs is proposed for descriptor linear systems.
外环则针对负载转动惯量的变化，设计了基于内模原理和零极点配置的自校正控制器。
To against variety of load inertia, a zero pole placement self tuning regulator basing on inner model is designed in the outer loop.
在多步极点配置的基础上，为实现系统部分极点的重新配置，引入了反向极点配置策略。
Based on pole assignment of multi input control, an inverted strategy of pole assignment is introduced to realize reassigning some poles of a vibratory system.
本文通过一个定理，给出了广义系统极点配置的可行性，解决了分块阵的子块的存在性问题。
In this paper, feasibility concerning the pole placement of generalized system was discussed by a theorem and the existence of submatrix Awas solved.
本文以实际的焦炉煤气集气系统压力过程为对象，介绍一神极点配置自校正调节器设计的新方法。
By the practical pressure process of coke oven gas collection system as object, a new method of to design pole placement self-tuning regulator is introduced in the paper.
本文以实际的焦炉煤气集气系统压力过程为对象，介绍一神极点配置自校正调节器设计的新方法。
By the practical pressure process of coke oven gas collection system as object, a new method of to design pole placement self-tuning regulator is introduced in the paper.
应用推荐