电感电流断续工作的反激式变换器一次侧开关可工作于硬开关或准谐振(或谷值开关或零电压开关)模式。
The flyback converter running in discontinuous conduction mode can be operated in hard switching or quasi resonant (or valley switching, or ZVS) mode regarding the primary side switch.
它有两种工作状态：电流连续和电流断续。
There are two operating modes: current continuous and current discontinuous.
连续波与断续波（续波）的频率、电流、电压、脉冲宽度均相同，声电波的频率、电流、电压、脉冲宽度均为不断变化的。
Frequency, current, voltage and pulse width of successive wave and intermittent wave were similar. Frequency, current, voltage and pulse width of sound electric wave changed continuously.
当输出滤波电感的电流在一个周期内不连续时，移相全桥PWM变换器就工作在电流断续模式（DCM）。
Phase-shifted full-bridge PWM converters work in discontinuous current mode (DCM), when the current of out-put filter inductor is discontinuous in one switching period.
本文提出了工作在电流断续状态下可逆传动系统结构形式的选择与数字调节器的设计方法；同时配以仿真研究结果。
A selection method of the structure of reversible transmission system with pulse electric current and a design oJ digital regulator are put forward and the results of emulating study are also given.
分析了直流调速系统电流断续对传动控制系统的影响及电流自适应调节器的功能，并举例说明电流自适应环节的调试方法。
This paper analysis the effect of discontinuous current on DC drive system and the function of current-adaptive control, and illustrates its adjusting method.
并且提出了基于模糊控制的原理来补偿电流断续的情况下的触发延时角。
And the current make-and break compensation based on fuzzy control was given.
根据电感上电流的断续情况，开关变换器可以工作在连续导电模式（CCM）和断续导电模式（DCM）。
The switch convertor can work in continuous current mode(CCM) or discontinuous current mode(DCM) according to the current through the inductance.
本文分析了两路交错并联双管反激变流器的工作模式，采用开关平均法建立了电流断续模式（DCM）下的变流器小信号模型。
The operation modes of the interleaved double-transistor flyback converter have been analyzed. The DCM small signal AC model using the averaged switch method has been built up.
为解决原系统所存在的结构合理性、电流断续和参数选择等问题，提供了合理方案和可靠依据。
The rational scheme and reliable basisare provided for solving the problems about the rationality of constructions, current cutting-out and parameter setting existing in the primary system.
为解决原系统所存在的结构合理性、电流断续和参数选择等问题，提供了合理方案和可靠依据。
The rational scheme and reliable basisare provided for solving the problems about the rationality of constructions, current cutting-out and parameter setting existing in the primary system.
应用推荐