变频器在保护跳闸后故障复位之前，将一直显示故障代码。
Inverter in protection tripping, after before the fault restoration will always show failure code.
故障指示器的自动复位时间可跳线选择2小时或4小时。
Fault indicator automatically reset the time Select jumper to 2 hours or 4 hours.
手动复位报警信号，如果信号复位还是报故障则向项目工程师或是领导报告。
Handle reset alarm signal, if there is still in failure, technician on duty must report to project engineer or leader.
你将能够演出两场的双向沟通，与你的车，观景及复位故障码，服务时间间隔，以及更多！
You will be able to perform two-way communication with your car, viewing and resetting trouble codes, service intervals, and much more!
给出了看门狗、掉电后供电延时、电源故障实时监控和自动复位等功能的实现电路及相关程序。
The implementing circuits of watchdog, delay on power outage, power failure monitoring and automatic reset and related program are given.
不复位定影器故障代码复印工作就不能进行。本文以佳能、夏普和理光复印机为例，介绍70多种型号复印机定影器故障代码的复位方法。
This paper takes more than 70 kinds of Canon, Sharp and Ricoh of PPC for example, recommends way resetting trouble-codes of PPC fuser units.
透视机发生故障时可能需要放弃闭合式髓内针固定或经皮骨折固定，而代之以切开复位固定。
Closed intramedullary nailing or percutaneous fracture fixation techniques may need to be abandoned for an open technique if the image intensifier fails.
除了自动复位的故障以外，其它可远程复位控制故障引起的原因有以下几种：风机控制器误报故障；
In addition to automatically reset the fault, other faults can be caused by a remote reset control for the following reasons are several: fan controller, false failures;
从软件与硬件两个方面介绍了如何在MCS-51单片机控制系统中使用看门狗技术，对看门狗监控复位后的故障处理方式提出了一些解决方案。
This paper introduces how to use watchdog technology in MCS-51 single-chip computer control system from hardware and software two sides.
从软件与硬件两个方面介绍了如何在MCS-51单片机控制系统中使用看门狗技术，对看门狗监控复位后的故障处理方式提出了一些解决方案。
This paper introduces how to use watchdog technology in MCS-51 single-chip computer control system from hardware and software two sides.
应用推荐