摆块机构是根据两极限位置的传递力矩之和最大进行优化的。
The slider mechanism is optimized on maximum sum of transmitted torques at the two limiting positions.
分析了凹模摆块机构的几何运动，设计了相应的弯曲模结构，可为类似零件的成形提供参考。
The geometrical movement of the swaying block of the matrix is analyzed. The corresponding die structure has been designed. It can serve as a reference for forming similar parts.
电动门滑动控制机构工作过程如下：有电时，齿轮与齿条啮合，由于摆块顶住齿条使管状电机带动外套管转动。
The sliding door control mechanism works as follows: when there is electricity, the gear and rack meshing, as the pendulum block against the rack to drive the outer tube tube motor rotation.
当再次有电时，拉动拉索，拉索带动摆块，摆块另一端的复位机构带动摆块下移；
When the power again, pulling the cable, cable drives the swing block, the other end of the swing block reset mechanism drives the swing block down on the rack;
当再次有电时，拉动拉索，拉索带动摆块，摆块另一端的复位机构带动摆块下移；
When the power again, pulling the cable, cable drives the swing block, the other end of the swing block reset mechanism drives the swing block down on the rack;
应用推荐