打开电源开关，电源指示灯亮。
指示灯亮显示门未关好。
开上电源开关，电源指示灯亮表示电源接通。
Turn on the power switch, the power indicator light is lit, which means the power is connected.
当“禁止吸烟”的指示灯亮时，请您熄灭香烟。
Please extinguish your cigarette when the 'no smoking' signs lights up.
当“禁止吸烟”的指示灯亮时，请您熄灭香烟。
Please extinguish your cigarette when the 'no smoking 'signs lights up.
冻结指示灯亮，压缩机无法启动，泵正常运转。
When the freezing indicator light is on, the compressor will not function but the pump still works.
按下保温开关，保温指示灯亮，水壶开始保温。
Press heat preservation switch to light up the indicating lamp, the water kettle will start heat preservation.
此时，红色、白色及黄色的加热器状态指示灯亮；
前进：按下fwd键，传送带前进，上方绿色指示灯亮。
Forward: Press FWD key, conveyor forward, the top of the green indicator light.
当电机工作正常，指示灯亮电机，当电机报警，指示灯将闪烁。
When the motor work up to snuff, the LED is light; when it have alarm, the LED is flicker.
当出现内阻报警时报警指示灯亮，当出现电压报警时电压指示灯亮。
When internal resistance is alarmed, the alarm lamp lights; when voltage is alarmed, voltage indicator lamp lights.
插上电源线插头，顺时针扭转调理温度旋钮，加热指示灯亮，即可进行加热。
Connect the power supply, turn the regulator knob clockwise, and the indicating lamp is lit, then it is ready for heating.
检查外接电源后，没有发现什么问题，去掉外接电源，也不能使电脑指示灯亮。
External power supply after the inspection did not find any problems, remove the external power supply, indicator light does not make computers.
当电压、谐波测量显示值超出设定的上、下限保护值的范围时，控制器报警指示灯亮。
When display value of voltage is out of the scope of upper and lower limit protection value, alarm indication lamp of controller is lighted.
是的，电源指示灯是亮的，机器也正在运行，但是不知怎么的声音就是出不来。
Yes, the power indicator was on, and it was running, but somehow the sound didn't come through.
“允许点火指示灯”亮。
电源指示灯是亮的，并且正常工作，但是为什么声音就是出不来呢?。
Thee power indicator was on, and it was running, but somehow the sound didn't come through.
电源断电或充电电路出现短路、过流、过热时，充电器上的充电指示灯均不亮。
A short circuit, over current and over heat are short circuit, over current and over heat, and the charging indicator light on the charger is not bright.
在运行过程中，如果指示灯闪烁5min后长亮，也表示SRS系统出现故障。
In the course of operation, if the indicator light flashes after 5min long bright, also indicates that the SRS system failure.
插上电源，打开电源总开关，电源指示灯随即著亮；
Plug in the power, turn on power switch, power indicator light then the light;
没有电池情况下，接上电源，4个指示灯是亮的，LED为绿色。
Plug DC power into charger, 4 indicators are light, LED is green(no battery)
A键：设置键，按一下A键正常使用模式，此时只有第一个是指示灯常亮，有空中鼠标功能和无线遥控器功能。
Button A: setting button. Press button A for normal use mode. At this time, only the first indicator keeps on and the air mouse functions and wireless remote controller functions are available.
再按下A键进入游戏模式，此时只有第二个指示灯常亮，此模式下适合玩鼠标类游戏。
Press Button A again to enter game mode. At this time, only the second indicator keeps on. Under this mode, the mouse games are available.
热水器打不着火的解决方法：检查交流电源插头指示灯是否亮，先排除电源供电部分的疑问。
Water heater can't fire solution: check the ac power plug lights are bright, to rule out power supply part of the question.
打开电源的时候，电源指示灯是常亮的才是正常的。
Open the power supply when the power indicator light is Always is normal.
当检测到病员呼叫时，控制器指示灯常亮并发出报警声。
Controller's indicator is normal on and send out alarm signal when detecting patient on sickbed calling.
如果电源指示灯同样不亮，请用万用表测量总开光是否有AC 380v的电压。
If the power light is still not on, check whether or not the main switch is with AC380V voltage by the universal meter.
如果电源指示灯同样不亮，请用万用表测量总开光是否有AC 380v的电压。
If the power light is still not on, check whether or not the main switch is with AC380V voltage by the universal meter.
应用推荐