中间抽头变压器由于两个副边线圈是分时工作，其线圈损耗模型不同于无抽头原副边线圈同时工作的变压器。
The winding loss model of central-tapped transformer in SMPS is different from that of the non-tapped transformer because the two secondary windings work in different time intervals.
如果变压器灯丝绕组有抽头，请不要使用它。
改良输出变压器还是基于麦氏的原始想法，也就是说，变压器还是按照传统的推挽输出设计，而且初级绕组具备中央抽头。
The output transformer USES the original idea presented by McIntosh, that is, the transformer is designed for a conventional push-pull output and the primary windings are halved.
本文提出一种基于变比变化检测的变压器抽头位置跟踪估计算法。
In this paper, a transformer tap position tracing estimation algorithm based on turn ratio changing detection is proposed.
详细介绍了一个带有中间抽头的高频大功率变压器的设计过程和计算方法，以及要注意的问题。
The design processes, calculating methods and noticeable problems of a high-frequency and power transformer with a midpoint tap are presented.
大多数商业使用多个抽头的变压器开关稳压器在不加控制的时间继电器水龙头，从而产生电压尖峰！
Most commercial voltage regulators using multiple-tapped transformers switch taps with relays at uncontrolled times, thereby creating voltage spikes!
如果变压器灯丝绕组有抽头，请不要使用它。
If the filament transformer has a center tap, don 't use it.
探讨了变压器分接抽头确定的实用方法，这些方法用在工矿企业的变压器的运行控制中取得了较好的效果。
The ascertaining means of a transformer shunting tapping is discussed. These means are used in running control of factory transformer getting good results.
采用高漏抗抽头式变压器，强迫风冷结构。
With high leakage fight to take a percentage type transformer, force air-cooling structure.
采用高漏抗抽头式变压器，强迫风冷结构。
With high leakage fight to take a percentage type transformer, force air-cooling structure.
应用推荐