使用一台可调气氛高温抗压实验机测量了在高温下焦炭的抗压强度与失碳率的关系。
The compressive strengths of coke at high temperature with relevant carbon loss rate were measured using a high temperature compressive machine with adjustable atmosphere.
并对其抗压、抗折、新老界面粘结强度及抗冻性等进行了实验研究。
Bending strength, compressive strength, interfacial bond strength and frost-resistance were also studied and analyzed.
本文实验研究了低温养护对普通混凝土和高性能混凝土的抗压强度的影响。
This paper experimental studies the effect of low temperature reservation on ordinary concrete and high performance concrete.
实验结果表明：依据该配合比设计方法所配制混凝土的抗压强度与期望值具有良好的一致性。
Experiments results show that using the systematical high performance concrete mix proportion design method can produce concrete with compressive strength cohere well with the expected one.
实验表明，算法还具有较好的隐藏效果和很好的抗剪切、抗压缩等功能。
Experimental results show the algorithm has a good effect of hiding, anti-cutting and anti-compressing.
通过对其抗压强度的实验研究，证明干硬性混凝土具有高强度、水泥用量少等特性。
According to the pressure proof intensity test research, this concrete is testified to be more advantages than high intension and little concrete dosage.
实验结果对于提高制件的抗压强度有指导意义。
The result of this experiment is of great-guidance to improve the compressive resistance of the pattern.
对发泡聚苯乙烯(EPS)填充水泥基体复合材料的吸波性能与抗压性能进行了实验研究。
The wave absorbing properties and compressive properties of expanded polystyrene (EPS) filling cement composite materials were studied in this work.
实验和分析研究表明，新提出的方法在估计就地混凝土抗压强度精确。
The experimental and analytical studies show that the newly proposed method is accurate in estimating the in-place concrete compressive strength.
复合材料的抗压强度用电子万能实验机测试。
The compressive strength of the composite was measured using a electronic universal -testing machine.
岩石的点荷载实验法简便、迅速、可靠、成本低，能在现场间接确定矿岩抗拉强度与抗压强度。
The point load testing as a simple, rapid, reliable and cheap method can determine indirectly the tensile and compressive strength of rock in the field.
实验表明，水泥试块在水灰比为0.38 ~ 0.62时，水泥试块的声阻抗与抗压强度间呈非线性关系。
It was found that a nonlinear relationship existed between the two physical parameters, when water and cement ratio was 0.38 ~ 0.62.
方法：ADFC设计成空心状柱体，截面为多边形，并进行了降解实验、抗压测试。
Methods: ADFC was designed as hollow column, and the section is polygon. Disintegration and compressivestrength were carried out.
实验表明：随污泥含量增加，烧制成品的抗压强度显著下降，抗折强度略有增加。
The results show that with the increase of sludge content, the compressive strength of the sludge tile decreases rapidly and the flexural strength increases slightly.
介绍了寒区混凝土无机防护剂产品，并且通过实验研究测定了该防护剂产品对混凝土抗渗性、抗冻性以及抗压强度的影响。
This article introduces an inorganic protective agent for concrete in cold climate, and the influence on impermeability, freezing resistance and compressive strength were analyzed.
实验结果表明，型块抗压强度与粉煤试样中暗淡煤含量呈线性关系；随着暗淡煤含量的增加，型块的抗压强度增强，煤成型性能变好。
The testresults show that the compressive strength of the briquettes has a linear relationship to content ofdull coal in the coal sample.
虽然受实验条件所限，作者未能做大量的实验并进行全面的分析，但所有实验数据都显示出电液压脉冲方法能提高混凝土的抗压强度；
The results of the experiments indicate that using strongly polar activated water to improve the mechanical performance of the concrete is practical and feasible.
实验验证，该算法有很好的抗噪和抗压缩效果。
Experimental results show that the algorithm has good anti-noise and anti-compression effect.
实验结果表明：普通硅酸盐水泥中添加制备地质聚合物的原材料提高了水泥的抗压强度。
The results show that: Portland cement was increased when the compressive strength added to the raw materials prepared by Geological polymer.
应用实验表明，涂有乳化蜡型混凝土养护剂的混凝土模块抗压强度、吸水率和失水率均优于或等于传统养护。
The application results show that the intensity of resisting pressure, the ratio of absorbing water and the ratio of retention water of the concrete blocks spread or sprayed with the curing...
应用实验表明，涂有乳化蜡型混凝土养护剂的混凝土模块抗压强度、吸水率和失水率均优于或等于传统养护。
The application results show that the intensity of resisting pressure, the ratio of absorbing water and the ratio of retention water of the concrete blocks spread or sprayed with the c...
最后，通过仿真实验比较了各种抗压制性噪声干扰方法的干扰抑制性能，并给出了两种典型抗压制性噪声干扰方法的运算量。
Finally, the performance of jamming suppression methods is compared through simulation, and the computational load of jamming and clutter suppression methods is presented.
测定对照组和实验组的固化时间及最大抗压强度；
The maximum compression strength and setting time of the materials in experimental and control group were tested.
实验室测试包括筛分析及无侧限抗压强度测试。
Laboratory testing included sieve analyses and unconfined pressive strength testing.
而且，实验结果也表明，抗压强度的各向异性程度比其他各种物性指标的各向异性程度都要大。
In addition, the degree of anisotropy of tensile strength is largest compared with that of other physical properties.
而且，实验结果也表明，抗压强度的各向异性程度比其他各种物性指标的各向异性程度都要大。
In addition, the degree of anisotropy of tensile strength is largest compared with that of other physical properties.
应用推荐