结合X射线应力测量原理，建立出基体承载系数的X射线应力测量方法。
By using the principle of X ray stress measurement, the bearing stress factors of matrix in composites was measured.
校验系数作为评价桥梁承载能力的指标应该有比较严格的定义和较为准确的计算方法。
As the indicator of evaluating the carrying capacity of the bridge, calibration coefficient should have Strict definition and accurate methods of calculation.
传统的安全系数法确定地基承载力存在许多缺陷。
Conventional safety factor method for confirming the bearing capacity of foundation soil has many defects.
模型房屋的延性系数为2.43，模型房屋具有良好的水平承载能力。
The ductility factor of model is 2.43 and its horizontal bearing capacity is acceptable.
这种设计方法是在不改变主要设计参数的基础上，通过调整齿轮宽度，实现重迭系数的圆整，提高齿轮承载能力，延长使用寿命。
It doesn't change main designing parameters, and through adjusting the gear width, the round number of coincidence coefficient and the improvement of gear life and bearing capacity Can be realized.
合成材料具有更好的承载能力，更低的热膨胀系数，更好的耐磨性和更好的抗疲劳性能。
The composite material has resulted in greater load carrying capacity, a reduced thermal expansion, greater wear resistance and fatigue endurance.
带传动当量摩擦系数体现了V带较平带具有更高的承载能力。
The V-belt equivalent coefficient of friction indicates that the bearing capacity of Vbelt is higher than that of flat belt.
利用该模型分析钢管混凝土超高墩的非线性承载能力可靠度指标与敏感性系数。
The reliability index and sensitivity coefficients of CFT high piers were invested by the proposed model.
但目前，在我国公路桥梁规范中，对于桩基础仅给出轴向承载力的安全系数。
But nowadays, in the code of highway bridge only have safety coefficient for axial bearing capacity of pile foundation.
根据校验系数，评定该桥的实际承载能力。
Then the actual carrying capacity of Ma Shuihe Bridge can be evaluated based on the verification coefficient.
利用承载能力系数可算出更符合实际的各齿对分别承受的载荷。
The load on each mating teeth pairs may be calculated respectively through the use of the coefficient.
固结系数决定着桩的极限承载力在初期的发挥，但并不影响桩的最终极限承载力。
The effects of soil friction Angle and coefficient of consolidation on pile ultimate bearing capacity were both analysed.
依据扁铲侧胀试验的结果，对桩侧土水平抗力系数的比例系数进行了估算，并估算出单桩水平承载力设计值；
Based on dilatometer test result, the proportional coefficient of lateral resistance coefficient in pile's lateral soil, and the design value of single pile lateral bearing capacity is estimated.
本文用简明的几何推导，弹性力学的方法，推导出了轮齿受载弹性变形后同时啮合的确切齿对和承受载荷最大的齿对的载荷与总载荷的比例系数——承载能力系数。
The number of teeth pairs mating simultaneously and the proportion coefficient of the biggest load on a tooth to total load is derived explicitly by means of geometric method and elastic mechanics.
本文根据农业机械承受的实际载荷及其承载能力的统计特性，导出了选用安全系数的一般通用公式。
This paper has been derived general purpose formula for selection of factor of safety, from statistical nature of actual load and statistical nature of load cap-ability for farm machine.
并结合相关规范，探讨温室薄膜承载计算的安全系数的取值问题。
According to the relative criterion, the safety coefficient of bearing capacity for the greenhouse film was discussed.
载荷部分安全系数与所用材料无关，在第4.3.5对所有承载部件进行说明。
The partial safety factors for the loads are independent of the materials used a nd are stated for all load components in Section 4.3.5.
当此类拱桥出现面内稳定控制设计时，横向风载的作用对拱桥的稳定系数和极限承载力影响较小。
When the in-plane stability of such arch is in control of the bridge design, Transverse wind load has a little influence on the stability factor and ultimate load carrying capacity.
该方法基于可靠度思想，以达到用极限承载状态时的强度储备系数或超载系数来表征大坝安全度。
This method is based on reliability idea, and the dam final stability coefficient dam of is defined by the strength reserve coefficient or over loading coefficient at limit equilibrium state.
本文给出了计算钢压杆弹塑性稳定极限承载力的有限条塑性系数增量初应力法。
The paper presents a numerical method, named the Finite Strip Plasticity Coefficient Increment Initial Stress Method, to solve the elastoplastic stability ultimate loads of steel columns.
新型螺母承载能力大、摩擦系数小、动态性能好。
The novel nut has the advantages of high bearing capacity, small friction coefficient and good dynamic performance.
但是多元复合地基的设计理论和计算方法并不成熟，承载力发挥系数无法精确选取。
Because of the design-theory and the method of calculation are not mature, so that the efficiency factor of bearing capacity can not be selected accurately.
与约束烧结粘土砖墙相比，等效粘滞阻尼系数提高37%，受剪承载力提高25%。
Compared with confined clay brick wall, equivalent viscous damping coefficients is improved by 37 percent and shear loading capability by 25 percent.
利用jc法对两种承载力折减系数下的FRP加固轴心受压构件进行了可靠度计算。
For two different capacity reduction factors, calculate the reliability of concentrically compressed members strengthened with FRP using the JC method.
本文还以承载力系数为依据，比较了提高箔片轴承承载力的方法。
Different means to improve the load capacity were compared through load capacity coefficient.
研究了KK型节点和K型节点极限承载力之比（即空间作用系数）随节点几何参数的变化规律。
The laws of the ultimate capacity ratio of K-joints and KK joints (namely multiplanar coefficient) varying with the main geometrical parameters were obtained.
最后，在理论分析、数值模拟及试验验证的基础上，给出了CFRP的强度折减系数值和正截面承载力计算表达式。
Finally, based on theoretical analysis, numerical simulation and test verification, the strength reduction factor and the calculation expression of normal section bearing capacity of CFRP are given.
所述承载构件（34）的数量及其相关强度为所述承载组件（30）提供了初始安全系数。
The number of load bearing members (34) and their associated strengths provide an initial factor of safety for the load bearing assembly (30).
所述承载构件（34）的数量及其相关强度为所述承载组件（30）提供了初始安全系数。
The number of load bearing members (34) and their associated strengths provide an initial factor of safety for the load bearing assembly (30).
应用推荐