该方法以测量的应变值为基础，由拟合的曲线方程计算接头载荷，并与试验时施加的总载荷对比。
In this method, based on the measured strain values, the joint load is calculated by the fitted curve equation and compared with the total load applied during test.
把所得极值与静水载荷、热载荷和兴波载荷相加，即得在给定的波浪遭遇次数中期望出现的总载荷极值。
Adding the stillwater load, thermal load and wave-making load to the above extreme response, the extreme total load expected to occur in a certain number of wave encounters is evaluated.
因为这种扁平的配置，施加到电缆上的机械载荷分散在其总宽度上。
With this flat configuration, the mechanical load applied to the cable is distributed over the total width of the cable.
同时比较SHR和WKY颈总动脉的平均血压和血流量、无载荷和载荷状态几何尺寸以及平均WSS和CS的特征。
The obtained blood pressure and blood flow, the geometrical sizes at no-load and load states, and the mean WSS and CS were compared between SHRs and WKYs.
计算结果表明：校核船体在气泡脉动载荷作用下的总纵强度的同时必须计入波浪载荷的影响，对相关理论研究和工程计算有一定参考价值。
Results indicate that the wave loads must be considered when the hull's longitudinal intensity is checked. The research has value to correlative theory research and engineering calculation.
根据设计任务书中规定的总的下潜次数要求，最后给出了我国目前正在研制的7000米载人潜水器耐压球壳的疲劳载荷谱。
According to the requirement of the total diving number and the assumption of the distribution type, the fatigue load spectrum for the 7000m deep manned submersible is given.
本文针对船型的特殊性，采用了适宜的载荷预报方法，妥善地解决了该船体的总纵强度、剪切强度及横向强度。
In accordance with the special characteristics of this type of ship, a proper load predication method is adopted for hull longitudian strength, shear strength and transverse strength.
结果表明：优化载荷分布的叶栅和原叶栅相比，总流动损失明显降低。
The test results have shown that the flow losses of cascades with optimized load distribution are significantly reduced in comparison with the original cascade.
再将温度引起的热应力和外力(如边界条件)之和作为力载荷施加到物体，求得总变形量。
Exert hot stress and external force (such as border terms) that temperature cause as the strength load the object and then, try to get total deformation amount.
在总厚度不变时，破坏载荷，弯曲强度及弹性模量都随金属厚度增加而增加。
Result When the whole thickness of the samples were determined, the fracture load, bending strength and elastic modulus were increasing according the increase of the metal thickness.
船体载荷计算对总纵强度分析起着非常重要的作用。
It plays role very important in longitudinal strength analysis to calculate hull load.
攻击产生的总请求数，是最小的载荷集中，载荷的数目。
The total number of requests generated by the attack is the number of payloads in the smallest payload set.
为了表示电流总的作用，通常取正载荷子的流动方向为电流方向。
Conventionally, the direction of electric current is that of the flow of the positive ions.
无换向架链条抽油机的链条承受的总拉力为悬点载荷与平衡重的差值加连杆对链条的水平分力在链条上形成的附加拉力之和，受力状况优于普通链条抽油机，且能得到控制。
The force conditions of the chain on a chain drive pumping unit without reverse rack are much more favorable than that on conventional chain drive pumping units, and can be well controlled.
攻击产生的总请求数，是载荷集中载荷的数目。
The total number of requests generated in the attack is the number of payloads in the payload set.
一般而言，工程结构和构件总可以看成是在恒定初始载荷和附加可变载荷的联合作用下工作。
Generally speaking, engineering structures and components can be always looked on as working under invariable original loads and additional variable loads.
最终，对应地迭加在外载荷及边缘载荷作用下的变形数据，即可求出密封环端面的总变形值。
Finally, the total mechanical deformation of seal rings can be obtained by superposition of the results due to the external loads and the edge loads respectively.
最终，对应地迭加在外载荷及边缘载荷作用下的变形数据，即可求出密封环端面的总变形值。
Finally, the total mechanical deformation of seal rings can be obtained by superposition of the results due to the external loads and the edge loads respectively.
应用推荐