介绍了直接压痕法、弯曲压痕强度法等几种韧性测试方法。
The method of toughness test such as Direct Crack Measurement and Indentation Strength by Bending etc. Are also introduced.
人工模拟降雨的模拟方法，有强度法、中径法和能量法，其中以能量法的效果最佳。
The rainfall simulation method refers to the approaches in intensity, medium-diameter and energy, of which the method by energy could get optimum result.
强度法是干涉型传感器采用的最古老、最简单的方法，它采用单色激光光源作为系统的光源。
The intensity modulation method is the oldest and simplest method for fiber-optic sensor, in which a homochromatic laser is used as system light source.
用成本效益改进价值强度法，对配电网拓扑结构改造方案的可行性和综合价值进行评价，优选最满意的改造方案。
It is relating to improved value strength of cost and benifit. It can be used to evaluate the feasibility and synthetic value of any reform scheme.
为了研究玻耳兹曼图法和谱线绝对强度法对测量结果的影响，讨论了电弧加热发动机羽流的光谱诊断方法，并建立了一套光谱诊断系统。
To determine the difference of the measurement results from different measuring methods, diagnostic principle for arcjet plume was discussed and a set of spectral diagnostic system was established.
基于小角X射线散射理论，利用逐级切线法和材料分形理论中的散射强度法，分别计算PAN基炭纤维内微孔大小、体积分数及微孔表面分形维数。
Based on SAXS theory and fractal theory, we obtain the calculating method and calculating formulas of the pore size, pore volume percentage and the fractal of pore surface in PAN - based carbon fiber.
结果表明，相对强度法能准确地测出单元推进剂HNIW在整个燃烧过程的温度分布曲线，测得的最高燃烧火焰温度低于相应压力下的理论计算温度；
The (investigation) results show that the curves of combustion flame temperature distribution in all combustion course are accurately measured by relative intensity method for monopropellant HNIW.
创建一种可直接依据“臭气浓度”源强、较易预测操作的“稀释度参数法”，对目前在恶臭环境影响评价预测中普遍采用的“臭气强度法”及“类比法”进行补充。
One dilution parameter method, which uses odor concentration to predict the impacts directly, is created as a complement method for present odor intensity method and analogy method.
如果你感觉通过练习“暂停-开始”法获得了更多的控制力，你下一步要尝试减轻刺激的强度而不是停止刺激。
If you feel you've gained more control with the stop-and-start technique, try changing your stroke to something less stimulating rather than stopping all together.
本文采用经典力学和有限元法对橇装海水净化设备进行了分析计算，在此基础上对系统本体进行了强度评定。
This paper analyzes the skid-mounted seawater purification equipment using classic mechanics and finite element method. On this basis, the system body is assessed for strength.
(包括“法本公司”和“西门子”)[见：译注1]。在那里盟国犯人和被绑架的外国劳工分配的食物很少，劳动强度非常大，以致每周有多达三分之一的人死亡。
G. Farben and Siemens among others, where Allied prisoners and kidnapped foreign laborers were fed so little and worked so hard that as many as one-third died every week.
本文叙述使用两个荧光参比溶液调节仪器的荧光强度测量法。
A measurement of fluorimetric intensity by using two fluorimetric reference solutions to check the instrument is described.
并用改变构件局部截面尺寸法，对构件锈蚀引起的结构强度变化作了简单的探讨。
And the effect of corrosion on structural strength is discussed in brief by changing section thickness.
针对磁通门传感器检测到的环境磁场强度信号，运用谐波选择法，设计了磁通门信号处理电路。
This paper adopts harmonic choice method to design fluxgate signal processing circuit in allusion to the environment magnetic field strength signal of fluxgate sensor detecting.
采用转移法生产反光材料，其反光强度高、外观光滑细腻、手感柔软，且防水、耐磨、耐洗。
The reflective material produced by transfer method, featured high reflective strength, smooth and fine appearance, soft handle, and water proof and abrasion resistance and washing resistance.
采用有限单元法对车体结构的强度、刚度、稳定性、挠跨比、扭转刚度进行计算，为车体设计提供了参考依据。
The strength, rigidity, stability and torsional rigidity of the bodywork structure were calculated by using finite element analysis. Thus the optimum fillet of the bodywork structure can be specified.
本文还根据试验结果和有限元法分析，探讨了空心砖墙的抗剪强度和横向、纵向配筋效应。
Based on the results of experiment and finite element analysis, the shear strength and the effect of reinforcement of the perforated brick walls are also discussed.
强度分析采用迁移矩阵法，稳定性分析采用样条能量法。
The strength is calculated by the transfer matrix method and stability is computed by spline energy method.
代谢评估法(map)测试是利用VO 2分析仪，在您进行低强度运动时，直接测量人体的代谢过程。
Metabolic Assessment Profile (MAP) test utilizes a VO2 analyzer to directly measure body processes while you perform a light workout.
对螺栓拉伸强度计算的载荷系数法作了进一步改进。
The load coefficient method of bolt on tensile strength calculation was improved.
采用细胞器-细胞荧光强度比值法，对HMME进行单细胞内分布的定性与定量研究。
Organelle-cell fluorescence intensity ratio analysis was adopted to study the intracellular distribution of HMME.
还探讨了边界配置法求应力强度因子时的收敛性问题。
The convergence problem of boundary collocation method used to calculate the stress intensity factor is also investigated.
为验证大棚骨架的强度，用农机测试中的应变测量法，来探索其内部应力的变化情况。
The strain test in the agricultural machinery field was used to probe the stress variation inside a frame in order to examine the strength of the plastics greenhouse frames.
经由简化光强度搭配有限元素法所得到的数据，模拟并讨论两者间的差异。
Through the simplification of intensity with the finite element method of data. simulation and discuss both the difference.
结果表明，双螺杆挤出法制备的凝胶拉伸强度高于溶液浇铸法所得样品的拉伸强度。
It is obtained that, firstly, the PVA hydrogels by extrusion have higher tensile strength than PVA hydrogels by the solution casting method.
利用有限元强度折减系数法求得的滑坡安全稳定性系数进行北门沟滑坡稳定性评价。
The stability assessment of Beimengou slope is achieved on the basis of the safety factor calculated by the strength reduction FEM.
利用有限元强度折减系数法求得的滑坡安全稳定性系数进行北门沟滑坡稳定性评价。
The stability assessment of Beimengou slope is achieved on the basis of the safety factor calculated by the strength reduction FEM.
应用推荐