短路、开路测试完成以后，在线测试仪需要在同一时间对印刷电路板上的每一个器件进行测试。
After performing the shorts and opens test the in-circuit tester tests each component on a PCB assembly one at a time.
最后，为了验证全速电流测试的可行性，我们通过利用PSPICE软件对C432电路中的一些故障做了模拟，这些故障包括开路故障、固定故障和冗余故障。
Finally, in order to verify the feasibility of at-speed current testing, by using PSPICE software, some faults were been simulated for C432, which included open fault, stuck fault and redundant fault.
根据地下参比电极接触测试原理，测试了套管被保护前后纵向深度上的套管自然电位、套管保护电位、阳极工作电位和阳极开路电位。
Through the contact test of underground reference electrode, we have tested the natural potential, casing protecting potential, the anode working potential, and the anode open circuit potential.
有一批显示器的故障相似，开机无显示，用万用表电阻挡测试电源线输入端，阻值为无穷大，说明电源线已呈开路。
There are a number of display similar to the fault, boot-free show that blocking electrical multimeter to test the power cord input, infinite resistance, has shown a way that the power cord.
蓄电池在安装时要对蓄电池外观进行检查，对单节开路电压作测试并记录。
Installed in battery to battery exterior inspection of single-section for the open circuit voltage tested and recorded.
通过对复合式牺牲阳极埋地运行参数的测试表明，管道保护电位达—1.4V，阳极开路电位在—1.5 V以上，是非常理想的镁阳极电位，其应用效果优于镁锌混合式方法，具有广阔的应用前景。
Shown from test of operation parameters on buried compound sacrificial anodes, pipeline protective potential is -1.4V and anode opened-circuit is over 1. 5V. It is a much ideal mag…
然而，两组通道必须被用于进行开路和短路校准，所以，系统最多仅能测试8个电容器。
However, two sets of channels should be used to perform open and short calibration, so the system can only test up to eight capacitors.
然而，两组通道必须被用于进行开路和短路校准，所以，系统最多仅能测试8个电容器。
However, two sets of channels should be used to perform open and short calibration, so the system can only test up to eight capacitors.
应用推荐