切割后，工件上的割渣应清理干净。
After cutting, the cutting slag on the work piece should be cleaned.
等离子切割：等离子切割后，割渣应清理干净。
The plasma cutting: plasma cutting, cutting slag shall be cleaned.
管子内部应清理干净，不得有焊接、锈皮及沙泥土、等赃物。
The inside of the pipe should be cleaned up, without welding, rust and dirt, sand and other stolen goods.
浇筑前，模板内的杂物、积水和钢筋上的污垢应清理干净，模板经现场监理检修合格后方可进行混凝土浇筑。
Before casting, template of the debris, in the water and reinforced of dirt should be cleaned up and to supervise the maintenance qualified by the template can be conducted only concrete casting.
钢筋端部200mm范围不应有锈蚀、油污、混凝土浆等污染，受污染的钢筋应清理干净后才能进行电渣压力焊焊接。
Within 200mm area of re-bar end surface, it should be free of rust, oil dirt, concrete slurry etc. The contaminated re-bar should be cleaned for electroslag welding.
其次，生锈的波形护栏板也应及时清理干净，并分类收回。
Secondly, the rusty corrugated guardrail plate should also be cleaned in time, and classified recovery.
其次，生锈的护栏也应及时清理干净，并分类收回。
Secondly, the rusty fence should also be promptly cleaned up, and classified recovery.
其次，生锈的护栏也应及时清理干净，并分类收回。
Secondly, the rusty fence should be promptly cleaned, and classified recovery.
其次，生锈的护栏也应及时清理干净，并分类收回。
Secondly, the rusty fence should be promptly cleaned, and classified recovery.
应用推荐