在变形监测点位稳定性分析中，平均间隙法是一种常用的方法，特别是在垂直位移监测网的稳定性分析中，其应用更为普遍。
In the analysis of the point stability for deformation monitoring, especially in height displacement monitoring network, the method of mean gap is commonly used.
测量减摩轴承轴承间隙并找出平均值。
Measure bearing clearance of antifriction bearing and find mean value.
平均径向间隙，外部渠道和全身清除直径轧制方向。
The average radial clearance, body clearance diameter of the external channels and rolling direction.
结果：经过平均41个月（最少2年）的随访期后，内距胫间隙、距胫腓角和距骨倾斜度获得改善。
Results: After a mean duration of follow-up of forty-one months (minimum, two years), the medial clear space, talocrural angle, and talar tilt had improved.
此外该模块还对间隙平均电压、峰值平均电压进行了检测。
Otherwise, the average gap voltage and average open circuit voltage are measured in this module also.
结果：1）影像学改变全部病例的施术腰椎间隙高度在术后均有不同程度的丢失，术后3年平均丢失26％。
Result: 1. The image change: the height of lumbar vertebrae interval of all cases have losing in various degree after operation, 3 years after the operation lose 26% on average.
间隙中的平均放电量随着空气间隙长度的增加而减小，随着施加电压的升高先增加后近似保持不变。
While, the mean discharge magnitude increase first and after that it has an approximate constant with the increase of applied voltage.
底部相对间隙在08～ 2 0之间时，扰流片高度小于边界层厚度时的壁面平均压力比扰流片高度大于边界层厚度时小30 %左右。
When the relative gap height (the ratio of flap height to gap width) is in the range of 0 8-2 0, the mean pressure will reduced 30% if the flap height is smaller than the thickness of boundary layer.
结果：随着关节面塌陷高度的增加，膝关节外翻角度、外侧间隙的平均和最大的接触压力逐渐增加，而接触面积则逐渐减少。
Results: increased articular step-off heights progressively increased valgus Angle, and average and maximum contact pressures, and progressively decreased contact areas in lateral compartment.
结果：随着关节面塌陷高度的增加，膝关节外翻角度、外侧间隙的平均和最大的接触压力逐渐增加，而接触面积则逐渐减少。
Results: increased articular step-off heights progressively increased valgus Angle, and average and maximum contact pressures, and progressively decreased contact areas in lateral compartment.
应用推荐