硕为将在本会展出最先进的多轴式锌合金压铸机与锌合金模具。
T -sok for will be exhibited in the most advanced multi-axis zinc alloy and zinc alloy die-casting machine mold.
钻床也许被分为三种一般类型：立式钻床、多轴钻床和摇臂式钻床。
The drilling machines may be classified into three general type:Vertical spindle, Multiple Spindle, and Radial Spindle machines.
介绍了集散式多轴拧紧机控制系统的设计原理及其在汽车工业网络制造管理中的应用。
This paper introduces design principle of distributed multi-axis tightening machine control system and application in network manufacture and management of automobile industry.
通过对某种国产拼接式多轴挂车转向机构的计算，证明了该方法的合理性和实用性。
According to one homemade combinable multi-axle trailer's steering system, the calculation in the paper proves this design method is reasonable and practicable.
特殊多轴旋转式自动收料机构；气压无轴式原料座。
Special designed multi-shaft running automatic rewinding device; Pneumatic shaftless unwinder.
三大航空集团的网络从单一枢纽为主向多枢纽转变，轴辐式结构更加明晰；
The networks of the "Big Three" are now shifting from single hub to multi-hubs and the adoption of hub-and-spoke structure becomes more obvious.
利用CAN总线数据帧的标识码设置传输报文的优先级，通过设计优先级晋升算法来改善多轴嵌入式数控系统报文数据通信的实时性和有效性。
The key design techniques of CAN interface were discussed. The priority of the transmitting message was set in terms of the identification code of CAN frames.
介绍了基于PC的开放式数控系统，以及一些集中体现了现代运动控制技术的产品。其中着重介绍了PMAC多轴运动控制器。
It also introduces the open NC system based on PC and some products, especially introduces the PMAC motion controller.
MIMS使用4个多轴压电式力传感器测量在门槛夹紧器中的力和扭矩。
The MIMS uses 4 multi-axis piezoelectric load cells to measure the forces and moments in the sill clamps.
本文提出的变磁阻式螺旋桨动力仪除用于水面船模试验外，并可用于水下模型及多桨轴模型试验。
The R. P. D. is presented in this paper. Except the usual ship model test, it is possible to carry out measurement of tests for the underwater model and multi-propeller shaft model.
基于DSP和FPGA技术，提出了一种分布式多轴交流伺服运动控制系统。
The main works are listed as follows:1. A distributed multi-axis motion control system, based on DSP and FPGA techniques, is proposed.
基于DSP和FPGA技术，提出了一种分布式多轴交流伺服运动控制系统。
The main works are listed as follows:1. A distributed multi-axis motion control system, based on DSP and FPGA techniques, is proposed.
应用推荐