但是将石墨单原子层冷却到接近绝对零度时，不可思议的事情发生了：电子的速度得到显著增加。
But cool this graphene down to near absolute zero and something extraordinary happens: the electrons speed up dramatically.
提高冷却速度和降低终冷温度可以增加针状铁素体的比例。
The ratio of acicular ferrite may increase by raising cooling speed and decreasing final cooling temperature.
微妙增加产出率或改变冷却速度，温度，或材料成分，可以产生新问题。
Subtle increases in production rates or changes in cooling rates, temperature, or material composition can cause new problems.
疾跑铭文：额外增加你“疾跑”技能的移动速度30%，但持续时间减少5秒。(之前是降低疾跑技能的冷却时间60秒)。
Glyph of Sprint - Increases the movement speed of your Sprint ability by an additional 30%, but reduces the duration by 5 SEC. (old - Decreases the cooldown of Sprint by 60 SEC.)
随着冷却速度增加，硬度值越来越大。
结果表明，随着冷却速度的增加，材料的硬度也越来越大。
The experiment results indicate that the hardness of the material increases with the increase of cooling rate.
结果表明：稀土使钢的过冷奥氏体转变曲线右移，在同样冷却速度下，加稀土钢的硬度增加。
The result shows that the RE make CCT curve move towards right and hardness of steel increases at same rate of cooling.
结果表明，熔体温度下降、所受拉伸比增加或冷却风速度升高均可使表观密度增加。
The results show that the apparent density of hard elastic polypropylene increases with a lower melt temperature, or a higher draft ratio, or a higher air blasting speed.
分析结果表明，冷却壁热负荷随着炉气温度的升高而增加，提高冷却水速度和壁体烧损变薄对热负荷的影响较小。
The results showed that heat load of stave was increased with increasing gas temperature. Increasing cooling water rate and decreasing stave wall thickness had small effect.
分析结果表明，冷却壁热负荷随着炉气温度的升高而增加，提高冷却水速度和壁体烧损变薄对热负荷的影响较小。
The results showed that heat load of stave was increased with increasing gas temperature. Increasing cooling water rate and decreasing stave wall thickness had small effect.
应用推荐