采用固溶过时效处理之后，耐磨性优于正常固溶时效处理的试样。
Compared with the samples prepared by normal aging treatment, the test samples prepared by overaging treatment have better wear resistance.
研究表明，对铝锂合金接头进行分级固溶时效处理、可以有效提高强度，改善塑性。
The result shows that this method can increase not only thetensile strength but also the ductility of the alloy 2091 welded joint.
结果表明，不同的孔结构参数以及固溶时效处理对多孔铝合金的压缩吸能性能有着显著的影响。
The results indicate that heat treatment and different pore structure parameters markedly affect the compression and energy absorption behavior of porous Al alloy.
结果表明：多重固溶时效热处理可以显著提高合金的塑性和断裂韧度，而对强度的影响不大。
The results showed that multiple solution and aging treatment had a significant effect on increasing plastic property and fracture toughness, although had little effect on strength.
结果表明，退火态2224铝合金经e CAP挤压后，进行固溶和时效处理，明显提高了合金的力学性能，细化了合金的晶粒。
It is shown that the mechanical properties of annealed sample of 2224 aluminum alloy are improved by the combination of solid solution and aging treatment after ECAP, the size of grain is refined.
经固溶处理和自然时效的铝铜合金可以进行硬质阳极氧化。
Hard anodizing film could be obtained on Al-Cu alloy surface which had been treated with solid solution treatment and natural aging.
研究了经不同的固溶和时效方案处理的7711铝合金的力学性能，并结合微观组织进行了分析。
The mechanical properties of 7711 aluminum alloy under different solution and aging conditions were investigated and analyzed by combining with the microstructure.
研究了均匀化处理、固溶时效、冷变形时效等对铬青铜显微组织和性能的影响。
The microstructure and properties of chromium bronze after homogenizing treatment, solid solution and aging treatment, cool deformation and aging was studied.
介绍了固溶处理温度、淬火到时效间隔时间及时效制度等对2A70铝合金预拉伸厚板组织和性能的影响；
The effect of quenching temperature, the interval time from quenching to aging and aging institution to 2A70 aluminium alloy pre-stretching plate structure and properties are introduced.
应用取向分布函数(odf)研究了3104铝合金经不同温度固溶及时效处理后的冷轧织构组态。
The cold rolling textures of 3104 aluminium alloys after solution and aging were studied by means of orientation distribution functions (ODFs).
可省去固溶与过时效预处理工序。
There is no need for solid solution and overaging pretreatments in the superplastic deformation process.
研究了C194合金变形与固溶时效热处理工艺条件对其组织性能的影响。
This paper is about construction and characteristics of C194, which are effected by heat-treatment of solution and aging .
航空铝合金为了获得高强韧性，必须进行固溶与时效处理，在淬火过程中产生很大的淬火残余应力。
These precipitation-hardened aluminum alloys gain their high strengths through heat treatment involving a severe quenching operation, which introduces a very high level of residual stresses.
固溶时效热处理使压缩吸能能力随着孔隙率的增大而呈现规律性减小，并使能量吸收效率对孔隙率和孔径的敏感程度减小。
The energy absorption capacity decreased regularly along with the increase of porosity and the energy absorption efficiency became insensitive to pore size (d) and porosity (P_r).
通过固溶处理后自然时效，能有效地提高合金的综合力学性能。
The results showed that natural ageing after solution heat treatment led to increase the comprehensive mechanical properties effectively.
通过固溶后自然时效处理，可有效地提高合金的综合力学性能；
The results indicate that natural ageing after solution heat-treatment leads to the effective increasement of the comprehensive mechnical properties.
结果表明，在固溶与时效处理中间加入预时效处理可有效消除单晶合金组织与成分的不均匀性。
The effects of pre-aging treatment on segregation behavire of Ni-based single crystal superalloy CMSX-3 were also studied.
固溶时效热处理使压缩吸能能力随着孔隙率的增大而呈现规律性减小，并使能量吸收效率对孔隙率和孔径的敏感程度减小。
The energy absorption capacity decreased regularly along with the increase of porosity and the energy absorption efficiency became insensitive to pore size(D) and porosity(P…
固溶时效热处理使压缩吸能能力随着孔隙率的增大而呈现规律性减小，并使能量吸收效率对孔隙率和孔径的敏感程度减小。
The energy absorption capacity decreased regularly along with the increase of porosity and the energy absorption efficiency became insensitive to pore size(D) and porosity(P…
应用推荐