六西格玛黑带应该能够计算出一个分组发生频次分布数据的均值和标准偏差。
The Six Sigma Black Belt should be able to compute the mean and standard deviation from a grouped frequency distribution.
根据度量值计算出平均值和标准偏差。
From the measurements, compute the mean and standard deviation.
对于每一个变量，平均值和标准偏差的结果。
For each variable, the mean and standard deviation results are presented.
实验结果表明该方法提高了图像的熵和标准偏差。
Entropy and standard deviation are used to evaluate image fusion performance.
那么，如果重复执行度量过程，平均值和标准偏差会有多大变化？
Then how different would the mean and standard deviation be if the procedure were repeated?
那么这些异常值和分散度是怎么影响度量值和标准偏差的呢？
So how do these outliers and dispersion affect the values of the mean and standard deviation?
您已经看到均值和标准偏差，直观上您可能会觉得温度是正态分布的。
You have seen the mean and standard deviation, and intuitively you might expect temperatures to be distributed normally. Let's check
那么，如何用平均值和标准偏差判断两个任务中哪一个更快呢？
So, how can the mean and standard deviation be used to determine which of two tasks is faster?
变量静态加工控制图表指南。均值，中值，范围和标准偏差图表。
Guide to statistical process control charts for variables - charts for mean, median, range and standard deviation.
因此，如果在数据集内存在异常值的话，那么度量值和标准偏差会得到相应的定位。
Thus, if outliers are present within the dataset the mean and standard deviation are located accordingly.
在异常值非常明显的数据集中，中间值和标准偏差值不应该用作位置的度量值。
In datasets where outliers are evident, the mean and standard should not be used exclusively as measures of location.
使用平均值和标准偏差，您可以说明，68%的尝试是在 0.2秒到 1.3 秒之间。
Using the average and the standard deviation, you can interpret that 68% of the attempts were between .2 and 1.3 seconds.
本文介绍了以极差和标准偏差为基础的两种评定表述、方法，并对两者进行了水平比较。
In this paper, the author gives two assessment expressions based on gradation and standard deviation. Horizontal comparison is done between the two.
在最后的部分中，我们通过范例显示了中间值和标准偏差对于数据集内的分散度都没有多大的抵抗力。
In the final section we showed by example that both the mean and standard deviation are less resistant to dispersion within a dataset.
几乎不用怀疑平均值和标准偏差会收到异常值存在的影响，而中间值和IQR所受到的影响则较小。
There is no doubt that both the mean and standard deviation are effected by the presence of outliers, while the median and IQR are much less impacted.
面板和三维介绍了发达国家市场，巴西和德国的描述性统计。对于每一个变量，平均值和标准偏差的结果。
Whereas Egypt and Germany show higher growth rates for non-family firms, Thailand and Brazil show higher growth rates for family firms.
样品测量：单样品自动测量，测量次数2、3、5、10、50次任意设定，测量结束给出平均值和标准偏差。
Measurement of sample: single sample automatic measuring, measuring the number of times 2, 3, 5, 10, 50 set, measured at the end gives the average value and standard deviation.
这些工具完成对属性数据的频次、平均值、最小值、最大值和标准偏差的分析，并将结果存于一个新的表格中。
They perform frequency, mean, minimum, maximum, and standard deviation analysis on attribute data and save the results in a new table.
这些工具完成对属性数据的频次、平均值、最小值、最大值和标准偏差的分析，并将结果存于一个新的表格中。
This tool contains the following statistics types: sum, mean, minimum, maximum, standard deviation, range, first, and last. Available with any ArcGIS license.
可能是正态分布，也就是高斯分布，只要有平均值和标准偏差值，你就可以进行调用，大部分的值都是集中在平均值附近的。
It could be normal, everything, that would be a Gaussian, where if you recall there was a mean, and a standard deviation, and most values were going to be close to the mean.
然后得出基本情况，最好情况，最差情况下的净现值，再计算平均净现值和标准偏差，（粗略地）估计该项目的内部固有风险的大小。
Then obtain base-case, best-case, and worst-case NPV and calculate mean NPV and standard deviation to (roughly) estimate the magnitude of the risk inherent to the project.
事实上，最近我和一个同事讨论了关于标准偏差的重要性，以及它常常被人忽视的情况。
Actually, a colleague and I recently discussed the importance of standard deviation and how it is often simply ignored.
均应报告标准偏差、相对标准偏差和可信限。
Standard deviation, RSD and confidential limit should be reported.
然后我在这里再写一个高斯分布的函数，它的浮动值的平均值和，标准偏差值都除了2。
And then I could also do a Gaussian one here, with the mean of and the standard deviation of volatility divided by 2.
开发的算平均值，残差，标准偏差，和总不确定度。
C development numerical average, residuals, standard deviation, and the total uncertainty.
方法采用《消毒技术规范》(2002年版)有效氯含量测定方法以及标准偏差、方和根等统计学方法。
Methods Valid chlorine content measurement method and statistical methods such as standard deviation, and square and root etc in "Technical standard For Disinfection" (2002 version) was adopted.
首先对被分析物料实验测定取样标准偏差，或进行一些有关的化学测试和物理测试，以确定取样常数。
The sampling constants can be estimated by means of sampling relative standard deviation or some relevant chemical and physical informations.
其放射学检查证实和骨质疏松症等骨骼水质常见于标准偏差。
Radiographic studies confirmed bone demineralization and osteoporosis commonly seen in patients with RSD.
通常的例子，汇总数据的平均数，中位数和模式，而更复杂的标准偏差和泊松分布。
The usual examples of aggregated data are average, median and mode while the more complicated are standard deviation and Poisson distribution.
注：表中不确定度以定值标准偏差和样品的不均匀方差表示。
Note: Uncertainty in table is showed by the square minus of the standard deviation from laboratory average data and sample unhomogeneity.
应用推荐