根据扁平状黏土颗粒结合水膜形成模型，推导了结合水膜厚度计算公式。
According to the model of flat clay particles, a formula for the thickness of red clay particles is deduced.
根据圆形人工挖孔桩护壁厚度计算公式，编制了计算护壁厚度的电算化程序。
In accordance with the formula of thickness of support wall of ring-shaped excavated pile, the electronic calculation program of the thickness is programmed.
本文详细介绍了岩层真厚度计算公式，在袖珍计算器中进行计算程序编排的方法。
This paper introduces in detail the formula for calculating the true thickness of strata and the method for the programming of the calculation by use of the pocket calculator.
通过对金属复合轧制的变形分析，导出了多层金属复合轧制的包覆板坯厚度计算公式。
By the analysis of the deformation of metallic composite rolled products, a formula for calculating the thickness of covering slab for multilayer metallic composite rolling is derived.
本文从平衡滤光片的原理，推导了金属片型和塑料氧化物型平衡滤光片的最佳厚度计算公式。
The precise formulas, for calculating thickness of X-ray balanced filters made from metal foils or oxide-plastic films are deduced from the principle.
通过有限生命周期内微型冷库经济性能的分析，推导了微型冷库在使用年限不同时的经济保温层厚度计算公式。
The calculation equation of the economic insulating layer thickness in different service life was (derived) through the life cycle economical analysis of the mini-cold storage.
推导出了一般环境、酸性、碱性和盐环境下适用的GF R P筋混凝土保护层厚度计算公式和最小锚固长度计算公式。
Formulas for critical thickness of cover and minimal anchorage length of GFRP bars under ordinary and erosive environment were developed.
在分析研究波浪对砌块护坡作用机理的基础上，通过护面砌块稳定性系列试验得出了规则波和不规则波作用下的砌块厚度计算公式。
Based on an analysis of the mechanism of wave action on the revetment, formulae for block thickness under the actions of regular and irregular waves were obtained through a series of stability tests.
根据内绝热层的烧蚀机理，推导出内绝热层炭优厚度计算公式；根据燃烧室壳体对热防护的要求，给出了确定内绝热层设计厚度的方法。
The formulas to compute the charred thickness are derived based on its ablation mechanism and the methods to determine its design thickness arc given based on thermal protection for the chamber case.
给出了一种线接触弹流问题中油膜厚度的理论计算公式。
A theoretical formula for computing the film thickness in line contact EHL problems is derived.
以立式拱顶储罐为例，根据限定的温降值和限定的温降时间，建立了确定储油容器保温层厚度的计算公式。
Taking vertical dome tank as an example, the calculation formula for insulation thickness of oil tank are given based on controlled temperature drop and duration.
在平板叠加理论的基础上，建立了一个有限长对称矩形压力容器的设计模型，并推导出其侧板厚度的计算公式。
A design model of a finite length rectangular pressure vessel was established based on the plate heap theory, the calculation formula of the side plate thickness was derived.
根据弹塑性力学及围岩-支护相互作用原理，分析了竖井稳定性，推导了竖井围岩与支护的应力、位移以及支护厚度的计算公式。
Based on plastoelasticity mechanics and surrounding rock-supporting principle, the stability of shaft was analyzed, and calculation formula of stress, displacement and support thickness were derived.
对质子交换光波导生长机理进行了研究并给出了波导层厚度的计算公式。
The growth mechanism of proton exchanged waveguides was studied, and the formula for calculating the depth of the waveguides was deduced.
针对两种非线性温度梯度模式及具有不同顶、底板厚度的一般箱梁桥，推导了等效线性化后的特征参数计算公式。
The formula of characteristic coefficient for equivalent linearization is derived for two kinds of thermal gradient modes and general box girders with different depths of top and bottom flanges.
提出了热及电场诱导的多载流子模型，在完全耗尽近似下，得出了耗尽区厚度和电场强度的计算公式。
Under the approximation of the full depletion, the calculating formulas for the width and electrical field of depletion region are obtained.
为了弥补目前采用的各种镀层厚度测量方法之不足，本文提出利用镀层元素一次X光激发的基底金属二次荧光进行膜厚测量的设想，并推导出相应的计算公式。
A suggestion was made to measure thin-film thicknesses using second X-ray fluorescence from substrate excited by primary X-ray of plating element, and corresponding equations were derived.
对波浪边界层厚度提出明确的定义，利用相似原理导出了波浪紊流边界层厚度的合理计算公式；
This paper presents a precise definition of the thickness of wave boundary layer. The thickness equation of the turbulent boundary layer beneath water waves is derived by the principles of similarity.
对波浪边界层厚度提出明确的定义，利用相似原理导出了波浪紊流边界层厚度的合理计算公式；
This paper presents a precise definition of the thickness of wave boundary layer. The thickness equation of the turbulent boundary layer beneath water waves is derived by the principles of similarity.
应用推荐