介绍力矩式自整角机转子交轴阻尼短路环损耗和电流的一种测试方法。
A test method of torque synchro rotor quadrature axle damping short-loop loss and current was introduced.
论述了俄罗斯、美国和中国航天服手臂阻尼力矩的测试方法，比较了各种方法的特点。
The spacesuit arm damping torque measuring methods of Russia, USA and China are presented in this paper.
导弹舵电动加载系统的硬件结构和工作原理的基础上，因果关系，多余力矩的数学模型和测试方法进行了分析。
Based on the hardware structure and operation principle of the missile rudder electric loading system, the causation, mathematic model and test method of surplus torque are analyzed.
本文介绍了一种新的直接式测试力矩马达动态特性的方法——光电池法。
This paper describes a new direct type of test method, the light cell method used to research dynamic performance of the torque motor.
全面介绍了强化型管口轴承座的研制工作，进行了初步结构原理的动力学分析，并且测试了数种不同结构参数的轴承座的工作力矩特性。
The authors described in detail the development of the new bearing, which can enlarge the moment, using dynamics analyses of the structural principle.
经过约8周的训练，患膝屈伸肌群的峰值力矩在不同测试速度下均有显著提高，但伸肌峰值力矩提高较屈肌快。
After 8 weeks of training, knee extensor and flexor muscles strength can be improved, but knee extensor muscle torque increase more than flexor muscle.
介绍用常规测试仪表，测定起重制动器制动力矩变化率的方法，并对测定原理、数据处理作了说明。
The measurement method for braking moment variation rate of hoist mechanism with traditional instruments is introduced and its principle and data processing are described.
对受翻转力矩螺栓组联接的最大工作拉力进行测试与分析，提出符合实际受力状态的精确计算方法。
The maximum working pulling force of bolt-set connection under a bending moment is measured and analyzed. An accurate calculation method is presented, which tallies with the actual situation.
这个多元化模型和所有被测试的腰椎融合模型都被施加10.6Nm大小的伸屈力矩，所偏转的角度以度为单位记录。
The intact model and all fusion models were stressed with 10.6-Nm flexion and extension moments. The angular deflections were recorded in degrees.
同时，给出了力矩标定的算法及转速、力矩的测试流程。
The arithmetic about torque demarcation as well as the testing flow of rotate speed and torque were presented.
在单元件特性测试中，测试了力矩开关、油门台、自动油门伺服装置和轮盘传动组件等单元件性能。
The performances of the moment switch, the throttle handling device, the throttle servo device, and the wire-wheel assembly are concerned separately.
双侧膝关节屈伸肌群达峰力矩的时间（TPT）随测试速度的增加而减小，同一测试速度下伸肌达峰力矩的时间大于屈肌；
The time to peak torque(TPT) of junior athletes reduced with the test speed increasing and the time of extensors TPT are longer than flexors;
对受翻转力矩螺栓组联接的最大工作拉力进行测试与分析，提出符合实际受力状态的精确计算方法。
The maximum working pulling force of bolt-set connection under a bending moment is measured and analyzed.
对受翻转力矩螺栓组联接的最大工作拉力进行测试与分析，提出符合实际受力状态的精确计算方法。
The maximum working pulling force of bolt-set connection under a bending moment is measured and analyzed.
应用推荐