实验结果表明，该方法能有效校正初始控制规则并得到较好的控制效果。
The result shows that the method can effectively correct initial control regulation and get better control effects.
转子初始位置由霍尔传感器识别，并在转子开始转动后进行校正。
The initial position of rotor was checked and measured by Hall sensor, and was revised after the rotor starts to rotate.
具体分析了像差校正的原理和方法，编制了初始结构快速计算程序。
The principle and method of astigmatism correction were analyzed in detail, and the initial parameter computing was programed.
最大能量法的结果受初始静校正量的影响，它的解容易陷入目标函数的局部极小值。
The result of maximum energy method depends on the initial values of residual statics. The solution is often trapped into the local minimum of the objective function.
提出了用初始层校正法求解机电耦合系统状态方程组的方法，获得了问题的渐近解析解。
In this paper, a method of using initial layer correction to solve the electromechanical coupled systems is submitted, an asymptotic solution of analysis are obtained.
目前的传感器误差校正方法，由于都是以传感器初始标定数据作为依据，从而随着使用时间的增加，传感器参数发生变化，其校正误差会逐步增大。
At present, the correcting method of sensor error depends on sensor prime data so that when working time increases and sensor parameter is changed, the correcting error will increase.
最后，利用亮星得到的生长曲线对通过最优孔径测得的初始星等进行校正，能较好地提高暗星的测光精度。
Finally, using a growth curve from bright stars to correct the instrumental magnitude can improve measure precision of faint stars quite well.
软件部分由系统初始化与显示程序和中断服务程序组成，主要完成深度、速度的计算、各种校正处理及显示各种报警等功能。
The software consists of system initialization, display and interrupt service routines, which completes depth and velocity calculations, depth correction and alarm displays.
在折射静校正处理中应针对不同地貌特征建立初至拾取原则和初始速度模型，以确保折射静校正结果的准确可靠。
The results have been used to guide the pickup of first breaks and to construct initial velocity model for refrac…
在折射静校正处理中应针对不同地貌特征建立初至拾取原则和初始速度模型，以确保折射静校正结果的准确可靠。
The results have been used to guide the pickup of first breaks and to construct initial velocity model for refrac…
应用推荐