当用小于0.33C(除了BREAK - IN模式外)的电流对电池进行充电，充电器可能不能获得足够强的充电终止信号以截至充电。
When charging below 0.33c (except in BREAK-IN) mode, the batteries may not produce a sufficient end-of-charge signal for the charger to terminate correctly.
如果你想用很低的充电电流进行充电，应该使用BREAK -IN模式。此充电模式只会因为时间(1.6倍电池容量)和温度终止充电。
If low charging rate is desired, you should use the BREAK-IN mode. Charging in that mode is terminated by only time (1.6 times battery capacity) and temperature.
同样温度感应器会因为电池过热而终止充电，但由于充电电流太低，也不能另电池产生足够的热量让温度传感器感应。
Although the temperature sensors will safeguard battery overheating, lower charging rate might not cause enough heating in the batteries to trip the sensors.
当充电电流在达到最终浮充电压之后降至设定值的1/10 时， EMC5040将自动终止充电循环。
The EMC5040 automatically terminates the charge cycle when the charge current drops to 1/10th the programmed value after the final float voltage is reached.
当充电电流在达到最终浮充电压之后降至设定值的1/10 时， EMC5040将自动终止充电循环。
The EMC5040 automatically terminates the charge cycle when the charge current drops to 1/10th the programmed value after the final float voltage is reached.
应用推荐