XRD测定炭素材料的石墨化度 - 中南大学学报（自然科学版、英文版） 关键字: XRD;石墨化度;多重峰分离;内标[gap=1552]Key words: XRD; graphitization degree; multiple-peak separation; inter-standard
基于50个网页-相关网页
...墨化度和无序度的X射线衍射测定 关键词：石墨化度；无序度；全谱拟合；d 法；X射线衍射 [gap=1448]Key words：graphitization；disordered degree；whole spectrum fitting；d∞2 method；X—ray diffraction ..
基于24个网页-相关网页
... 石墨化退火graphitizingannealing 石墨化度graphitizinggrade 石墨化因子graphitizingfactor ...
基于22个网页-相关网页
Microsoft Word - 22-p0581.doc Key words: Ni-Fe alloy; electrodeposition; degree of graphitization; carbon fibers [gap=20981]关键词：镍−铁合金；电沉积；石墨化度；碳纤维
基于20个网页-相关网页
石墨化程度 degree of graphitization
After heat treatment, the degree of graphitization of the materials was about 30~50%, and the degree of graphitization of material l-6
石墨化热处理后，材料石墨化度约30～50％，其中1-6材料的石墨化度达到47.1％。
参考来源 - 航空发动机轴间密封C/C复合材料的制备及摩擦磨损特性研究High degree of graphitization in this manganese oxides coated fibers is observed clearly at HTT of 1600℃.
在1600℃下热处理就能得到高石墨化度炭纤维。
参考来源 - 聚丙烯腈基炭纤维的催化石墨化研究·2,447,543篇论文数据，部分数据来源于NoteExpress
沥青炭的室温电阻率随石墨化度的增加而下降，随体积密度的增大而下降；
The results show that the higher graphitization degree of pitch derived carbon is, the higher real density is.
结果表明纳米石墨中碳含量为90%左右，石墨化度为66%，表面碳原子以碳单质状态存在的占54%。
The results indicate that the content of carbon is about 90%, the degree of graphitization is 66% and the carbon of simple substance phase at the surface is 54%.
由实验结果可以看出、石墨材料的纯度、 石墨化度、显微组织结构等因素，对金刚石的合成效果及其性能均有显著的影响。
The experimental results showed that the effect of the purity, degree of graphitization, microstructure etc. factors on the synthesis result of diamond and properties.
应用推荐