... calcining furnace 焙烧炉,锻烧炉,煅烧... calcining heat 煅烧温度 calcining temperature 煅烧温度 ...
基于152个网页-相关网页
煅烧碳质页岩用作水泥混合材的研究--水泥工程杂志社 关键词:碳质页岩;活性;煅烧温度;水泥混合材 [gap=970]Keywords: carbonaceous shale; activity; calcination temperature; cement admixture
基于68个网页-相关网页
煅烧带温度 calcining zone temperature
The optimum preparation conditions are as follows:mass ratio of attapulgite to TiO2 1:3.0 and calcination temperature 450℃.
制备复合催化剂的最佳条件:凹凸棒土与TiO2的质量比为1:3.0,煅烧温度为450℃。
参考来源 - TiOAlso, theeffects of proportion of raw materials, calcining temperature and calcining time on photocatalytic property of composite were studied.
并研究了原材料配比、煅烧温度、煅烧时间对复合材料光催化性能的影响。
参考来源 - 纳米氧化锌/聚合物复合材料的制备及其光催化性能研究Reactant ratio, temperature of the reaction, PEG, ammonia dropping speed, reaction time and calcinations temperature had the important influence on the crystal size.
采用沉淀法制备纳米氧化镁,反应物配比、反应温度、表面活性剂的加入量、氨水滴加速率、反应时间和煅烧温度等工艺参数均对粉体有较大影响。
参考来源 - 纳米氧化镁系抗菌材料的制备与性能研究②Experimental results show that Calcined modified lithium slag optimum process parameters is, calcination temperature of 1000℃, calcination time of 45min,after rapid cooling and grinding 15min to be modified products.
②高温化学改性锂渣最佳的工艺参数:煅烧温度1000℃,煅烧时间45min。 煅烧后粉体经过急速冷却,粉磨15min后得到化学改性粉体。
参考来源 - 改性锂渣硅铝酸盐混凝土研究·2,447,543篇论文数据,部分数据来源于NoteExpress
摸索出合适的煅烧温度、煅烧时间等工艺制度。
The suitable process system, such as calcination temperature and calcination time etc. has been found out.
结果表明煅烧温度是干法制备氧化铁颜料的一个重要因素。
The results showed that calcinate temperature was an important factor in the preparation process of iron oxide.
激活剂用量和煅烧温度影响荧光粉的发光亮度,是主要控制因素。
The flux dosage and calcination temperature, which affect luminosity of the fluorescent powder, are the major controlling factors.
应用推荐