模具加热器/冷却器 Mold heaters/chillers ; Mold hegotrs/chillers ; Mold hedinedrs/chillers ; Mold hedined onrs/chillers
模头加热功率 Power of die heating ; die head heating power ; Mold Head Heating Power ; Head Tooling Heating power
模头加热段数 Number of heating zone ; die head heating zone ; number of die heating zone
模具加热炉 die oven
高频加热模 high-frequency electrically heated mold ; frequency electrically heated mold
模块加热器 Block Heater
模具加热关闭 MOLD HEAT IS OFF
加热模式 heating mode
蓄电池加热模块 BTM
模具加热降低 MOLD HEAT LOWERS
它可以同时加热合金丝与拉丝模,并使它们分别获得不同的温度。
It can heat wires and its die at the same time and can give them different temperature.
在粉末锻造中,压制零件一般加热到远低于该材料通常烧结温度的锻造温度,然后在闭模中锻造。
In powder forging an as-pressed component is usually heated to a forging temperature significantly below the usual sintering temperature of the material and then forged in a closed die.
在加热模套时,可放入少量颗粒木炭,通过木炭的燃烧消耗氧气达到减少氧化烧损的目的。
As heating die sleeve, a few grain charcoal is added and oxygen is consumed by charcoal burning so that oxidation burning loss is reduced.
应用推荐