The result of RVPFEM simulation shows that the preform with optimized H/D dimension can significantly reduce hammering times and die wear.
有限元数值模拟结果表明获得的预成形H/D最佳尺寸可明显减少模锻锤击次数和模具磨损。
参考来源 - 基于刚粘塑性有限元模拟的汽轮机叶轮模锻的预成形优化·2,447,543篇论文数据，部分数据来源于NoteExpress
研究结果表明，该模具磨损非常小，瓶盖质量比以前更好；
Research results show that, the mould wear is very little. Cap quality is better than before.
数值模拟结果表明获得的预成形H/D最佳尺寸可明显减少模锻锤击次数和模具磨损。
Numerical simulation results show that the optimal preform H/D dimension thus obtained can greatly reduce hammering times and die wear.
实践证明，这些措施能很好消除塑料模具磨损现象，从而提高了塑料模具寿命和生产产品的质量。
These methods have been proved very effective in the avoid wear of plastic dies, to extend the lifetime of dies and to improve the quality of plastic products.
应用推荐