This paper makes reference to much relevant information and analyzes different technique of machining, and finally adopts roll-pressing to process spirally grooved tube. Main parameters of spirally grooved tube have diameter of tube, wall thickness, corrugation depth and fin pitch.
本论文参考了大量的有关资料，分析了不同加工工艺特点，最后采用了滚压成型的生产工艺来加工螺旋槽管，其主要结构参数有管材外径d、壁厚t、槽深e、螺距p。
参考来源 - 螺旋槽管材滚压成型的数值模拟及实验研究·2,447,543篇论文数据，部分数据来源于NoteExpress
为提高灵敏度，考虑了槽状的光入射区，阐述了槽深的选取原则。
To improve sensitivity, a grooved light-incident region is considered and the selection of the groove depth is discussed.
槽深不能太浅，槽口宽应该适当取大些，中心互作用空间不宜太窄。
The width of the groove should be widened relatively, and the space of the interaction area should not be too narrow.
实验确定了获得最大热流密度时的微槽表面尺寸为槽宽、槽深以及槽间距分别为0。
When the maximum heat flux density is acquired, the experiment confirms the groove surface size as follows: 0.
应用推荐