本程序确定了检查、无损检验和试验相关的程序控制,并提出了一套体系和指示要求。
The purpose of this procedure is to provide for a system, instructions and to identify the procedural controls associated with inspection, non destructive examination and test activities.
功能指示螺纹规是为了检验通端的最大材料限度及大小及止端的有效直径限度及大小。
Functional Indicating Thread Gage for inspecting the maximum-material GO functional limit and size and the NOT GO functional diameter limit and size.
根据公司指示执行中期或最终检验。
Perform IPQC inspection and final inspection according to the instruction.
应用推荐