挤压时的上升温度 temperature rise
The maximum extrusion force and therising value of temperature during extrusion deformation increased with the decrease of extrusion temperature.
最大挤压力和挤压温升随挤压温度的降低而增大。
参考来源 - 7075z铝合金高温塑性变形行为研究·2,447,543篇论文数据，部分数据来源于NoteExpress
挤压温度过高或过低导致界面结合强度降低。
The bonding strength of the composite interface is reduced when too low or too high extrusion temperatures are employed.
结合实际挤压实验，确定了合理的挤压温度和挤压速率范围。
Based on the test results, the appropriate extruding temperature and extruding velocity were determined.
结果表明，随着挤压温度的降低和挤压比的升高，最大挤压力逐渐升高。
It was suggested that the maximum extrusion force during extrusion was increased with the decreasing extrusion temperature and the increasing extrusion ratio.
应用推荐